Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Keep a material certificate on hand for compliance and quality assurance needs. Certificates include a traceable lot number and material test report. These hollow shafts reduce system weight and allow you to run various media such as electrical wiring, compressed air tubing, coolants, or lubricants through the center.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

These shafts include a support rail for a stable setup that eliminates bending and prevents linear bearings from rotating.

At approximately one-third the height of standard versions, these rails provide linear shaft support in applications with low vertical clearance. They provide stability over the entire length of shaft, allow virtually unlimited travel lengths, and eliminate bending under moderate to heavy loads.

These two-piece supports allow access to the shaft without needing to slide out the shaft or uninstall the support. Use them to brace the end of a linear shaft when working with light to medium loads where shaft alignment is not critical. Tighten the included clamping screws to secure.

Create a support that fits the exact dimensions of your shaft. Good for use with square- and hex-profile shafts, these aluminum supports also work with round shafts of any diameter up to 1". Use them for light-to-medium-load linear motion applications where shaft alignment is not critical.

Because they usually do not require lubrication, linear sleeve bearings outperform linear ball bearings in dirty environments.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Thinner than standard linear sleeve bearings, these bearings fit where clearance is a concern.

These fiberglass bearings are lightweight, nonmagnetic, and won’t conduct electricity.

Made of FDA-listed materials for use in food applications, these bearings also have excellent chemical and corrosion resistance.

Virtually maintenance free, these bearings have slippery, chemical-resistant liners that don't require added lubrication.

A ceramic coating makes high speeds as well as rapid acceleration and deceleration possible.

With two bearings mounted in a single housing, these bearings have load capacities more than 10 times as high as standard mounted linear sleeve bearings. A ceramic liner helps them achieve high speeds as well as rapid acceleration and deceleration.

A ceramic coating makes high speeds as well as rapid acceleration and deceleration possible.

A ceramic coating makes high speeds as well as rapid acceleration and deceleration possible.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

With fewer moving parts and no need for lubrication, sleeve bearing carriages perform better in dusty and wet environments than ball and roller bearing carriages. They're also better at handling impact and vibration.

A handle on the side of the carriage locks the carriage in place.

Threaded inserts secure the bearing to the carriage and prevent it from loosening due to frequent starts and stops.

Fasten loads on the side of these carriages and add linear motion to a T-slot assembly.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.

Use these slides in a variety of manual-positioning applications for laboratory and production equipment as well as for positioning parts for drilling, fastening, assembly, and measuring.