A rubber gasket provides a watertight seal.

These boxes have durable hinges and are more shatter resistant than other compartmented boxes.

Adjust the dividers to create the size and number of compartments that you need.

These boxes are made with an additive that protects sensitive contents from electrostatic discharge.

Use a box as is, or snap on additional boxes to create a mobile storage system that fits your needs.

Drop, scrape, or spill on your robot teach pendants (also known as HMIs)—these protectors will guard them, preventing downtime due to damage.

Carry and protect levels in these padded bags.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components. These enclosures have a clear cover, so you can inspect components without opening the enclosure.

Mounting feet make attachment to machines and walls hassle-free. These enclosures are small and lightweight for use with sensors, switches, testing devices, and circuit boards.

Control access to these enclosures with a key-operated lock.

Internal mounting bosses or mounting brackets enable you to use panels or DIN rail to mount components. Enclosures are made of nonconductive polycarbonate that resists denting, chipping, and cracking.

PVC enclosures are nonconductive and chemical resistant, withstanding solvents, alkalies, and acids.

Mounting feet make attachment to machines and walls hassle-free.

Made of fiberglass, these enclosures are lightweight and won’t rust, but still shield push-button controls from water, dirt, and oil.

Small and lightweight, these enclosures are used with sensors, switches, and testing devices.

These enclosures withstand temperatures up to 475° F.

Made of nonconductive polycarbonate, these enclosures withstand prolonged submersion in water while protecting electronics from dents, chips, and cracks.

Able to withstand periodic submersion in water, these enclosures offer our highest level of protection from liquids. They’re made of fiberglass to resist impact and corrosion from solvents, alkalis, and mild acids.

Install these enclosures on control panels and walls and inspect what’s inside without exposing their contents in wet and outdoor locations.

Inspect components without opening the cover.

Mount these enclosures directly to machine control panels in wet environments and view the contents without opening them.

Two separate chambers allow you to access wiring connections in the lower section without disturbing components that you install in the upper section.

Protect keypads, push-buttons, and other handheld controls with these round enclosures that are more comfortable to hold than square enclosures.

Suitable for installing in the ground or for use in wet environments, these direct burial enclosures are rated NEMA 6P for protection from dirt, washdowns, corrosion, and water submersion.

Use these open boxes with adhesive for electronics (also known as potting compound) to encase electronic assemblies and protect them from vibration, tampering, moisture, and corrosives.

A 9-volt battery fits inside a compartment in these enclosures to power testing devices and other hand-held instruments.

Create battery-powered, hand-held devices such as card and signal readers—these enclosures have a clear cover for checking screens and status lights inside.

Protect monitors and televisions from environmental damage with these enclosures.

Easily access HMI devices, push-buttons, and other electronics mounted on the exterior of an enclosure while keeping contents safe from water, oil, dust, and weather.

These pouches fit onto most hand-held power drills and impact drivers. They have a magnetic panel on the front that can hold bits and fasteners.