Blades are ceramic to stay sharp longer than metal blades.

For extra leverage to cut through tough materials such as leather, rope, and thick cardboard, these scissors have long handles and short blades. The blades are corrosion-resistant stainless steel with a serrated edge that grips material to prevent slipping. Handles are offset to keep your hand clear of the material as you cut on flat surfaces.

Titanium nitride extends blade life and is nonstick.

After each cut, the jaws spring open to make continuous cutting easy. The blades are plated for added durability and serrated to grip material and prevent slipping.

For extra leverage to cut through Kevlar, metal, and plastics, these scissors have long handles and short blades. The blades are plated for added durability. One blade is serrated to grip material and prevent slipping.

Produce clean edges in a variety of pliable materials. Also known as scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut. Blades do not close completely.

A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips. A spring opens the jaws for quick cutting, and a locking latch holds them together when the cutter is not in use. Blades are serrated to prevent slipping.

Make round, square, and irregular-shaped holes with this punch-style hole cutter. Drill a 7/16" dia. starting hole, then push the cutter through the hole and squeeze the handles together to cut out small pieces of material.

Leave clean cut edges in a variety of pliable materials. Also known as scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut. Blades do not close completely.

Style A has spring-action jaws that open automatically. Style B has long handles for better leverage. Style C has spring-action jaws that open automatically. It also cuts tie wire. Style D has long handles for extra leverage when cutting wide straps. Styles E and F cutters reduce the chance of worker injury from sharp flying strap ends. They hold both ends of properly tightened strapping until tension is released. Style E uses leverage for additional power. Style F has rubber compression pads for greater control of tight straps.

Two-handed strap cutters give you more leverage than one-handed strap cutters.

Styles A and B have an offset lower handle for cutting heavy steel strapping easily and preventing bruised knuckles. Style C reduces the chance of worker injury from sharp flying strap ends. It holds both ends of properly tightened strapping until tension is released and has rubber compression pads for greater control of tight straps.