Use these polypropylene flanges in outdoor environments—they resist the damaging effects of ultraviolet light. Flanges have the chemical resistance to stand up to a wide variety of acids, solvents, and other harsh substances. Also known as Class 150 flanges, they have thick, strong walls for heavy duty chemical processing applications. Bolt two same-size flanges together with a gasket (sold separately) to create an access point within a line. When connecting to pipe, apply a non-hardening, plastic-compatible sealant to the male pipe threads to prevent leaks. Tape or sealants with PTFE are not recommended for plastic-to-plastic threaded connections. When making a threaded connection be careful not to overtighten the threads. To prevent cracks and leaks, finger tighten the flange, then wrench-tighten one to two turns.

Warning: Never use plastic pipe flanges and pipe with compressed air or gas.

For technical drawings and 3-D models, click on a part number.

Flanges have excellent corrosion resistance to handle a wide range of acids and other highly-corrosive chemicals. Use in metal surface treating applications, plating solution lines, and other chemical process applications. They are reinforced with fiberglass layers for better strength and durability than any of our other pipe flanges for chemicals. Bolt two same-size flanges together with a gasket (sold separately) to create an access point within a line. Flanges meet ANSI/ASME B16.5 and ASTM D4024 specifications and testing requirements for product dimensions, performance, and material quality.

To connect flanges to pipe, first sand the inside of the flange and the end of the pipe to remove the surface finish. Next, mix the adhesive (sold separately) until the color is uniform with no streaks. Apply a thin layer of mixed adhesive to the sanded area of the pipe, approximately 1/8” thick. Repeat this process with the inside of the flange, applying a layer approximately 1/16” thick. After sealant has been applied, push the flange onto the pipe until it is fully engaged. Make sure you align the bolt holes prior to installing to minimize rotation after the flange is installed. Finally, use the adhesive-curing heat cable (sold separately) to cure the adhesive. Wrap the tape around the pipe and flange at the joint, taking care to not overlap the tape. Once you have waited the full cure time, the pipe and flange will be ready to use.

Warning: Never use plastic pipe flanges and pipe with compressed air or gas.

Snap these caps into flange bolt holes to safeguard pipe flanges during shipping, storing, and finishing applications. They all have a thick center pad to protect the flange opening and pipe threads from damage.

For technical drawings and 3-D models, click on a part number.