In addition to a low-friction surface that prevents sticking and binding, this tough material is impact and wear resistant to handle the scuffs, scrapes, and strikes that other plastics can’t.

This material suppresses static charges to prevent dust from building up.

Compared to our standard UHMW polyethylene, these sheets and bars hold up better to scuffs and scrapes in high-speed, high-precision, and high-impact applications—such as conveyor equipment, chute liners, and machine guards. Also known as Tivar HPV.

If a chip of this material breaks off, it can be located by metal detectors to reduce contamination risks.

Delrin® acetal resin, also known as acetal homopolymer, is stronger and stiffer than acetal copolymer.

An economical alternative to Delrin® acetal resin, this acetal copolymer offers similar wear resistance.

Because this polypropylene resists swelling when exposed to water, it’s often fabricated into containers and parts for laboratory equipment.

Also known as nylon 6/6, this general purpose material is often used for bearings, gears, valve seats, and other high-wear parts.

A layer of soft LDPE is sandwiched between two thin layers of aluminum for strength and rigidity.

Known for its electrical insulating properties, this polystyrene is often used for cable connectors, electrical housings, and in microwave applications. It is also known as Rexolite.

The addition of glass fibers to this polycarbonate increases tensile strength for use in structural applications.

These black polyester sheets protect from UV rays better than off-white polyester. Strong and semi-rigid, they won't swell in moist environments, so they're often made into pump components and spacers.

Made with virgin Teflon® PTFE resins, these sheets and bars surpass most plastics when it comes to chemical resistance and performance in extreme temperatures.

This film is made with virgin Teflon® PTFE resins. It can handle extreme temperatures and resists most solvents.

Not only does PEEK provide superior wear resistance in repetitive processes, it is also resists wear caused by abrasion. PEEK can be used as a lightweight substitute for metal parts in chemical-processing applications.

Common in food and pharmaceutical plants, these PEEK sheets and bars help you identify contaminated batches.

Often used for circuit-breaker housings, manifolds, and semiconductor components, Ultem PEI offers excellent electrical-insulating properties.

Stronger than PTFE, PVDF offers good chemical resistance. Comparable to Kynar and Solef, it’s widely used for pump parts, tank liners, and seals.

Widely used to make parts that require autoclaving, polysulfone is a hard, rigid material that’s easy to machine and thermoform. It maintains its physical properties when heated, even when exposed to steam.