Made of recycled UHMW plastic, these sheets and bars are an economical, environmentally friendly alternative to standard UHMW while still offering the same low-friction surface that prevents sticking and binding.

Compared to our standard UHMW polyethylene, these sheets and bars hold up better to scuffs and scrapes in high-speed, high-precision, and high-impact applications—such as conveyor equipment, chute liners, and machine guards. Also known as Tivar HPV.

Practically nonabsorbent, HDPE won't swell when exposed to moisture. It is denser and more rigid than LDPE, plus it's more chemical resistant.

An economical alternative to Delrin® acetal resin, this acetal copolymer offers similar wear resistance.

Because PVC resists many acids and alkalies, it’s widely used for tanks and in chemical-processing applications. Also known as PVC Type 1.

Add stiffness to composite sandwiches without adding a lot of weight.

Widely used in semiconductor applications, this polypropylene meets UL flame-retardance standards.

This nylon 6/6 material is modified with MDS for a self-lubricating surface that’s more slippery than standard nylon. It's often used in high-friction applications, such as gears and bearings.

The addition of MDS results in a nylon with exceptional wear resistance as well as self-lubricating properties.

This nylon stays lubricated over time because it’s filled with oil. Use it to fabricate parts for hard-to-reach places where adding lubricants would be difficult.

Polycarbonate maintains good impact resistance across a wide temperature range. It's comparable to Lexan, Hyzod, Tuffak, and Makrolon.

Use Noryl PPO for electrical insulating applications where moisture is a concern. It remains dimensionally stable over time, even when temperatures fluctuate.

Widely used to make parts that require autoclaving, polysulfone is a hard, rigid material that’s easy to machine and thermoform. It maintains its physical properties when heated, even when exposed to steam.

Cast acrylic is easier to machine than extruded acrylic. It's comparable to Lucite and Plexiglas® Acrylic.

These Garolite CE sheets and bars are often fabricated into parts where high strength is not required.

Rated for temperatures down to -320° F, this Garolite G-10 CR performs better in cryogenic applications than other glass epoxies.

Protect electronic components from electrostatic shocks and chemicals while safeguarding them from bumps and drops during shipping and storing.

In addition to being lighter in weight than silicone foam, this polyimide foam also remains soft and conformable across a broader temperature range.