These spacers have excellent wear and abrasion resistance. Exposure to moisture may cause them to expand.

Polypropylene spacers have a hard surface and resist many chemicals and solvents.

Use PEEK spacers as an alternative to metal spacers in high-temperature, high-stress applications. They resist chemicals, wear, and moisture.

PTFE spacers have a slippery surface and surpass most plastic spacers when it comes to chemical resistance and performance in extreme temperatures.

Cut stock to the length you need.

Stick these supports to surfaces where you don't want to drill a hole. The snap-in end can be released for repairs and upgrades.

Secure the self-tapping female connection with a screw; the other end snaps snugly into a panel, yet can be released for repairs and upgrades.

Designed for multi-level printed circuit board applications, these self-aligning, through-hole supports have a chamfered female end for stacking. The other end snaps and locks in place for a permanent connection.

Also known as shoulder washers.

The extra-tall sleeve extends into holes to provide more protection than other rolled-collar washers.

In addition to having a wider temperature range than our other vibration-damping bushings, these have excellent weather resistance.

Ribbed bushings are more flexible than our smooth vibration-damping bushings, so they're easier to install.

Use where high loads and speeds are not required.

Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Good for underwater applications, these bearings won’t swell or warp when wet.

Compensating for minor shaft misalignment and not requiring lubrication, these sleeve bearings swivel to self-align and are dry running. They don’t need a housing and you can install and replace them without any tools because they’re slip fit.

Use where high loads and speeds are not required.

Permanently and securely install these self-clinching bearings into panels, with no need for precision-bored holes or machined mounts.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Good for underwater applications, these bearings won’t swell or warp when wet.

Use where high loads and speeds are not required.

Use these bearings in applications with frequent starts and stops because they operate with very little friction.

Good for underwater applications, these bearings won’t swell or warp when wet.

These nylon bearings swivel inside their housing to compensate for over 20° of shaft misalignment.

Made from slippery materials, these bearings reduce friction without the oily mess.

Use these nylon or acetal bearings for light loads. The closed backing blocks out dust and other contaminants.

Embedded lubricant particles increase the load capacity of these bearings while also making them slippery.

Mount items not designed for DIN rail by attaching them to these adapters.

Made from a single piece of slippery UHMW plastic, these bearings have no cracks or crevices so they’re easy to clean.