Press these fittings onto stainless steel pipe using a crimping tool for a permanent, leak-tight connection that's faster than threading or welding and doesn't require heat. Fittings have an internal stainless steel gripping ring and rubber O-ring that create a seal when crimped. They are designed to leak if fittings have not been crimped; a colored dot marks the leak path so it's easy to spot unsealed connections. All of these fittings are made of 304 stainless steel to resist corrosion from frequent exposure to water and fuels. They’re often used for water processing lines, heating and cooling systems, and fuel lines. They are comparable to Viega MegaPress fittings.

Fittings meet ANSI/ASME B31 code requirements for use in pressure piping systems.

For technical drawings and 3-D models, click on a part number.

Heat oil or coolant inside small containers to reduce the viscosity of the liquid and improve flow. These heaters fit in compact openings that are 1 NPT or smaller. With a low-watt density, these heaters operate efficiently and won’t burn out when used with a wide range of oils and coolants. The heating element is made of stainless steel, so it resists corroding when exposed to chemicals.

Both ends of these heaters are threaded, so one side fits into your tank and the other can be threaded into a conduit to protect the wiring. For the most evenly distributed heating, choose the largest length of heater that will fit in your container. To control the settings of the heater, they must be connected to a temperature switch or controller (required but not included).

Note: Fully submerge the heating element in liquid to prevent heater failure.

For technical drawings and 3-D models, click on a part number.