Valves have a brass body.

Our smallest pressure-regulating valve.

For easy panel mounting in your water system, these valves have threads below the adjustment knob and come with a panel-mount nut.

A cast iron body absorbs vibration from pressure changes to reduce wear and noise in your pipeline.

To maintain contaminant-free standards in clean room environments, these valves come cleaned and bagged and have a 316 stainless steel body with a smooth finish to resist dust collection.

Thicker walls and a 304 stainless steel seal make these valves tougher than brass pressure-regulating valves.

For extremely high-pressure applications in tight spots, these valves handle the same inlet pressures as other ultra-high-pressure-regulating valves within a smaller footprint.

Regulate air, gas, liquid, and steam pressure on food, beverage, and pharmaceutical lines with these valves—they’re 3-A certified to meet sanitary design standards.

Designed for oxygen service and other high-purity applications, these valves can withstand the extreme cold of liquid argon, liquid carbon dioxide, liquid nitrogen, and liquid oxygen.

Adjust airflow equally in both directions. These valves regulate the speed of airflow as it enters and exits equipment. They're often used to control the extension and retraction speed of an air cylinder at the same time.

Designed to be mounted inline, these valves can be installed in an easy-to-reach location along your line. They control the speed of air-powered equipment by adjusting the volume of airflow.

A swiveling outlet port on these valves makes connections from any direction. They control the speed of air-powered equipment by adjusting the volume of airflow.

Designed to be mounted inline, these valves can be placed in an easy-to-reach location along your line to control the speed of air-powered equipment by adjusting the volume of airflow. A numeric indicator provides a relative measure of airflow, similar to the volume dial on a speaker, so it's easy to set the same flow rate with each use.

A numeric indicator provides a relative measure of airflow, similar to the volume dial on a speaker, so it's easy to set the same flow rate with each use. Mount them directly to cylinder ports, eliminating additional tubing between the cylinder and valve for better control than inline valves. They control the speed of air-powered equipment by adjusting the volume of airflow.

Mount these valves directly to cylinder ports, eliminating additional tubing between the cylinder and valve for better control than inline valves. Made of plastic and stainless steel parts, they have excellent corrosion resistance. They control the speed of air-powered equipment by adjusting the volume of airflow.

Prevent damage to your equipment by limiting startup airflow and then gradually raising the airflow rate to operating levels.

A padlock locks the handle of these valves in the shut-off position so you can disconnect air tools safely.

Slide the knurled sleeve in one direction to stop flow, and slide it back to start flow again.

Turn airflow on and off with your foot to keep your hands free to perform other tasks.

Install these valves on your air tank outlet—at the end of the day, they automatically close to save energy.

Also known as air fuses, these valves close automatically to turn airflow off when air volume exceeds the shut-off flow rate.

Prevent air from escaping an air storage tank when the air compressor is not running. These valves open to allow flow into the tank and close when flow stops or reverses direction.

Convert a continuous stream of air into a series of quick pulses, reducing air consumption by up to 50% and improving performance in air-blowing applications such as cleaning and drying.