This general purpose hose for blowing and vacuum applications has a thick PVC wear strip that protects against damage caused by dragging.

The small bend radius makes this hose easy to wrap around corners and install in tight spaces.

The ends of this hose have a belt-and-buckle connection that eliminates the need for clamps.

A metalized polyester cover reflects heat so the temperature inside the hose won’t rise.

Our most versatile duct hose for blowing and venting air, this polyester hose is lightweight and very flexible.

Tightly braided fibers give this sleeving excellent abrasion resistance. As it wears, the fibers frizz and make the outer wall thicker for improved protection.

Tested to meet MIL-STD-202, this sleeving meets performance standards for flame retardance. It stretches to fit over items for easy installation, then tightens around its contents for a secure fit.

Reduce the likelihood of slipping in high-traffic areas. This sleeving has thick, nonslip fibers that create friction so it doesn’t slide when you step on it. It stretches to fit over items for easy installation, then tightens around its contents for a secure fit.

Snaps keep this sleeving securely closed, yet permit quick access to contents and allow you to route wires in between the snaps. Use it to easily wrap around wire, cable, and hose without disconnecting them.

A strip of hook-and-loop creates a strong seal along the entire length of this sleeving, yet it can be opened at any point to access contents. Use it to wrap around wire, cable, or hose without disconnecting them.

Unlike traditional sleeving that bunches wire and cable into a circle, this sleeving holds them flat, so it’s good for tight spaces such as vehicle interiors. It has a slit along the entire length so it easily wraps around wire and cable without disconnecting them.

Coated with PVC, this polyester sleeving resists chemicals and solvents. It has a slit along the entire length so it easily wraps around wire, cable, and hose without disconnecting them.

Flame rated VW-1, you can safely use this sleeving on wiring in multi-level facilities as well as in industrial machinery and vehicles. A hook and loop strip along its length makes it easy to wrap around components without disconnecting them and easy to open at any point to access them.

With a copper and nickel exterior and conductive lining, this sleeving shields your wire and cable from signal interference. You can wrap this sleeving like tape around wire and cable while they’re installed, so it’s great for emergency patches.