Made of FDA listed materials for use in food applications, these bearings also withstand caustic and washdown environments.

This sleeving absorbs UV light, so it can be used in direct sunlight without getting damaged. A reusable alternative to tape and cable ties, it allows you to route wire and cable between the spirals.

A slit along the length makes this sleeving easy to install over wire, cable, and hose without disconnecting them. The corrugated construction gives it impact and abrasion resistance similar to conduit, with more flexibility.

A hinge along the entire length makes this one-piece sleeving easy to open for installation. Interlocking ridges overlap along the opening to protect contents from dust and dirt. The corrugated construction gives it the impact and abrasion resistance of conduit, with more flexibility.

Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.

The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.

Create a water-resistant seal—this tubing has an adhesive lining that melts when the tubing is heated and bonds to the underlying surface.

Made of woven polyolefin/polyester fabric, this tubing has excellent abrasion resistance so it can be dragged over rough surfaces without damage.

Also known as halogen-free tubing, this tubing produces minimal amounts of smoke and gas if exposed to an open flame, so it can be used in enclosed areas such as ships and tunnels.

Approved for contact with food, this tubing is FDA Compliant 21 CFR 177.1330.

After being cleaned with alcohol, this tubing is bagged and sealed in a clean room. It's certified for material quality and purity.

Also known as breakout boots, these splitters insulate and seal the point where wire splits off from cable, or where cables exit from conduit.

Keep general purpose tubing in a variety of sizes on hand.

A different shrink ratio on each end allows this tubing to fit over cable assemblies and wire harnesses with large connections, or around connectors with a 90° elbow.

Polypropylene spacers have a hard surface and resist many chemicals and solvents.

An unthreaded barrel allows quick assembly with a press or a hammer.

These single-use gloves prevent cross contamination and provide the dexterity needed for intricate work.

Slip these covers over any bollard.

Use these to replace a damaged sleeve (ferrule) in quick-assembly compression nuts.

Use these nuts with plastic compression fittings to create a seal on plastic tubing. They have a built-in sleeve (ferrule), so the sleeve is positioned correctly for installation.

Use these nuts and sleeves with compression fittings for food and beverage to create a seal on plastic tubing.

These sleeves contain a corrosion inhibitor to shield metal parts from corrosion.

These tubes are easier to label and stack than round tubes. To adjust the length, push the ends of the tube together or pull them apart.

These tubes have one sealed end and one end that closes with a cap.

Covers fit loosely over the roller to allow packages to accumulate. Rollers can continue spinning inside the cover without causing damage to packages.

These flexible plastic caps are tapered to fit a variety of unthreaded and threaded objects.

Made of rigid plastic, these caps provide more wear resistance to the ends of angle iron than vinyl caps but are not as flexible.