Also known as tap-end and fixture studs, these rods have friction-fit threads on one end to resist loosening and standard threads on the other side for attaching a nut.

Use these buttons to support and position workpieces and fixtures from the bottom or side. Their hex shape lets you screw them into a threaded hole with a wrench or socket.

Mount through the counterbored hole with a socket head cap screw to support and position workpieces and fixtures from the bottom or side.

Support rounded or irregularly shaped workpieces from the bottom or side with minimal contact.

Maintain consistent alignment in mating parts by installing a pin in one part and a liner in the other.

Screw the shank into a threaded hole for quick installation and removal.

Encase these pins while molding plastic or composite parts. Once set, the knurls resist movement, letting you align the workpiece with precision on a plate or table.

A good choice for automated clamping, these retractors use compressed air to extend and retract a locating pin, protecting the pin from damage in applications where fixtures move through a process, such as along a conveyor belt.

When locating a workpiece using through-hole alignment pins, use one of these bushings and one standard bushing to prevent the pins from binding in your fixture.

Install tooling balls in a workpiece or fixture to create a precise measurement reference point. Push the shank further into the hole to adjust the height of the ball.

Protect tooling balls when not in use.

Thread in a screw, handle, or other part to create the right size and shape guide pin for your application.

Good for occasional machining, economy kits contain lower-strength components than standard kits.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".