Plastic pins are a nonconductive and nonmagnetic alternative to metal dowel pins. Use them as pivots, hinges, shafts, jigs, and fixtures to locate or hold parts.

Oversized to fit worn and enlarged holes, these pins work well as repair and replacement parts.

The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.

To remove these pins, thread a screw or tool into the tapped hole, then pull them out.

Use these as pivot or hinge pins. The knurled half locks pins in position, while the smooth half acts as a pivot.

The full length of these pins is knurled for a tight grip that won't spin.

For use with Browning shear hubs, these pins are designed to fail at specific loads to protect heavy duty machinery from torque overload.

Use these pins to fasten components made of soft materials such as plastic or aluminum. Opposing barbs bite into each piece, pulling them together for a tight, secure fit.

These pins make good hinges or pivots. The grooved half locks pins in position, while the smooth half can act as a pivot. Also known as type H pins.

Grooves run the full length of these pins for a firm hold that won't spin. Use them in place of standard dowel, spring, and taper pins to fasten parts. Also known as type A pins.

Quarter-groove pins are well suited for hinges or pivots. The grooved end locks pins in position, while the smooth portion can act as a pivot. Also known as type C pins.

These pins have a flat head to fit into a counterbored hole.

Push parts out of molds with these hardened pins. Also known as knockout and forged pins.

Use these pins with a die to punch 3/16" and larger holes. Pins can be modified to fit your application.

Choose a material, head type, end type, and size to create a custom pin.

Also known as roll, tension, split, and expansion pins, these pins have a slot along one side that you squeeze closed to install them into unthreaded holes.

For tough jobs, these spiral pins are 30% stronger than our standard coiled spring pins. They remain flexible after installation to absorb shock and vibration, and work well in holes that are out of round.

Threads on these pins stick out for easy removal from blind holes. Tighten the hex nut to draw the pin out.

These internally threaded pins sit flush in an assembly. For easy removal from a blind hole, thread a screw into the pin and pull out.

Weld these pins directly to a surface —no mounting hole required.

Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.

Slotted spring pins are also known as roll, tension, split, and expansion pins. Because the slot is pressed closed when the pins are inserted, they don't flex after installation.

Maintain consistent alignment in mating parts by installing a pin in one part and a liner in the other.

Screw the shank into a threaded hole for quick installation and removal.

Encase these pins while molding plastic or composite parts. Once set, the knurls resist movement, letting you align the workpiece with precision on a plate or table.

When locating a workpiece using through-hole alignment pins, use one of these bushings and one standard bushing to prevent the pins from binding in your fixture.

A good choice for automated clamping, these retractors use compressed air to extend and retract a locating pin, protecting the pin from damage in applications where fixtures move through a process, such as along a conveyor belt.

Set the tang in a slot below the work surface to prevent thin material from sliding underneath the face.

Thread in a screw, handle, or other part to create the right size and shape guide pin for your application.

Threading makes these guide pins easier to remove and replace than press fit, so they're useful for high-wear applications.

Support and position workpieces and fixtures from the bottom or side. These buttons press into a drilled hole for permanent installation.

Support rounded or irregularly shaped workpieces from the bottom or side with minimal contact.