Manually pump air, water, or hydraulic fluid through your system so you can test for leaks.

Easier to use than manual pumps, these use electricity to quickly pump water through your system so you can test for leaks.

Gauges have an accuracy of ±0.25%.

All-stainless steel construction makes these gauges suitable for testing and calibrating in corrosive environments.

These gauges have a glycerin-filled dial to reduce needle flutter for precise readings in high-vibration applications.

Tighten these threaded fittings with your hands for a secure connection in testing, flushing, venting, and plugging applications—no tools, tape, or sealant required.

Twist the wing nut on these plugs to expand the seal.

Tighten the nut on these plugs to expand the seal.

Turn the square head of the plug into the sealing ring to close off pipe openings.

Use the bypass tube to add air, water, and fluid or relieve back pressure.

Also known as pneumatic plugs, these plugs conform to wide and out-of-round pipes.

These plugs are designed for metal and rigid plastic tubing.

Measure your equipment’s pressure and send the data directly to a development board or single-board computer. Also known as transducers, these transmitters convert pressure into an electrical I²C signal and transmit it to your board.

Read pressure directly at the source and send data remotely with one device.

For use in wet environments, these transmitters are rated NEMA 4X for protection from washdowns and corrosion.

Monitor and control pressure in portable HVAC systems, hydraulics, and oil and gas equipment. Unlike other pressure transmitters that measure the difference between your system and the atmosphere, these transmitters give measurements relative to zero pressure—regardless of altitude or temperature.

These transmitters automatically compensate for error introduced by vibration as well as temperature fluctuations, so you do not need to program your receiving device to correct for these factors. They convert pressure to an electrical signal that can be interpreted by receiving devices, such as remote displays, programmable logic controllers, and motor speed controls to monitor pressure or control equipment.

Measure the difference in pressure between two process lines in flow applications such as heat exchangers, chillers, and pumps. These transmitters automatically compensate for error introduced by vibration as well as temperature fluctuations, so you do not need to program your receiving device to correct for these factors.

For use in hazardous locations, these transmitters safely measure the difference in pressure between two process lines in flow applications—such as heat exchangers, chillers, and pumps. They meet NEC safety standards, so they protect against an explosion where flammable gases and vapors are present.

Used in hazardous locations, these transmitters safely convert pressure and vacuum into an electrical signal to measure liquids, gases, and steam. NEC rated for safety, these transmitters are explosion proof, so they can be used in environments containing flammable gases and vapors.

Monitor and control vacuum pumps, air compressors, and hydraulics while viewing readings and warnings on the display.

The large dial makes these gauges easy to read. They measure tension force as well as weight.

Measure tension force as well as weight.

Housing is brass.

Weigh and measure tension force at a safe distance, up to 450 feet away, with these wireless gauges. Also known as dynamometers and crane scales, they’re used with cranes or hoists while moving material around your plant.

Hold fine wire and filament.

Good for gripping most shapes and materials.

Mount these sensors between a robot arm and a tool for precise control during delicate tasks, such as sanding or assembling small parts.