The faceplate is sealed to meet NEMA 4X and IP66 for protection in washdown environments with splashing water, corrosive liquid, and dust. The rear case meets IP20. These controllers have proportional-integral-derivative (PID) software with fuzzy logic that learns system behavior and automatically compensates for changes to achieve high accuracy in applications with fluctuating conditions. They read temperature with a highly sensitive thermocouple probe (sold separately) in critical process applications to turn heating equipment on or off at a specified temperature. All fit into instrument panels with DIN cutouts. Set actuation points with the keypad.

Controllers with automatic reset turn machines back on once the temperature decreases. Controllers with automatic/manual reset give you the choice to have machines turn back on either when the temperature drops or you reset their switch.

Controllers with 1/16 DIN trade size have one alarm relay.

Controllers with 1/8 and 1/4 DIN trade size have two alarm relays.

Mechanical relays actuate one circuit directly. Single pole, double throw (SPDT) relays can be set to turn the circuit from off to on (normally open) or from on to off (normally closed). Single pole, single throw (SPST) relay turns the circuit from off to on (normally open).

Solid-state relays actuate an external relay (not included). They have a longer service life than mechanical or signal relays.

Signal relays output 4-20 mA current to actuate equipment on a current loop.

For technical drawings and 3-D models, click on a part number.

Install these controllers into instrument panels. They read temperature with a highly sensitive thermocouple or RTD probe (sold separately) in critical process applications to turn heating equipment on or off at a specified temperature. Set the actuation point with the keypad. Controllers are single pole, double throw (SPDT). They can be set to turn one circuit from off to on (normally open) or on to off (normally closed).

These lightweight controllers have a carrying handle. They read temperature with a highly sensitive Type J thermocouple probe (sold separately) to turn heating equipment on or off at a specified temperature in critical process applications. Use the keypad to set the actuation point. All controllers are single pole, single throw (SPST). They have a control relay that turns one circuit from off to on (normally open). All come with a flat-pin connector for attaching a thermocouple.

For technical drawings and 3-D models, click on a part number.

Install these controllers in DIN panel cutouts to maintain your heating equipment’s temperature. When your machine gets too hot, they turn it on and off in short cycles to cool it down. Use them on electric heaters only—they won’t work with valves or solenoids. These controllers require a Type J thermocouple probe (sold separately) to read temperature. They have a mechanical relay that is single pole, double throw (SPDT), meaning it turns one circuit from off to on (normally open) or from on to off (normally closed). All controllers meet American, Canadian, and European safety standards.

To mount 1/16 DIN controllers to a surface or DIN rail, add DIN-rail/surface-mount adapters. To convert larger cutouts to fit 1/16 DIN controllers, add DIN cutout adapters.