When concrete is saturated with or submerged in water, use these epoxies to permanently set threaded rods, studs, and rebar. They form a weather-resistant chemical bond that seals out moisture and resists vibration and dynamic loads better than mechanical anchors. Warning: Allowable pull-out strength is 25% of ultimate values or less, as required by building authorities. Use a mixer nozzle and dispensing gun (dispensing gun sold separately) to simultaneously mix and dispense adhesive.

Permanently set threaded rods, studs, and rebar in concrete with these kits. They include applicators and mixer nozzles to simultaneously mix and dispense the adhesive. These adhesives form a weather-resistant chemical bond that seals out moisture and resists vibration and dynamic loads better than mechanical anchors. Warning: Allowable pull-out strength is 25% of ultimate values or less, as required by building authorities.

These adhesives maintain their strength in temperatures up to 250° F. Use them to permanently set threaded rods, studs, and rebar in concrete. They form a weather-resistant chemical bond that seals out moisture and resists vibration and dynamic loads better than mechanical anchors. Warning: Allowable pull-out strength is 25% of ultimate values or less, as required by building authorities.

Use the included mixer nozzle and a dispensing gun (sold separately) to simultaneously mix and dispense adhesive.

Bond new concrete to old concrete, or use this epoxy as a primer for epoxy coatings on concrete surfaces. Mix the amount you need; the size listed is the combined total of the two parts.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors. To install, first fill tubes with adhesive (sold separately) and press them into a drilled hole. Hold tubes in place by pressing the tab against your block, and insert a rod into them. The rod will push the adhesive out of the mesh screen, forming a plug that keeps the rod in place once the adhesive dries.

For technical drawings and 3-D models, click on a part number.

Mount to a surface and add a cable tie to secure a bundle.

Two-way mounts allow ties to be inserted from opposite sides. Four-way mounts allow ties to be inserted from any side. Any-way mounts allow ties to be inserted from opposite sides and have a head that spins to route the cable in any direction.

Screw-in mounts require a fastener. Adhesive-back mounts stick to any clean, smooth surface. Adhesive-ready mounts require an adhesive to create a strong hold.

Mounts that meet UL 94 V-0 stop burning within 10 seconds. Mounts that meet UL 94 V-2 stop burning within 30 seconds.

The disposable curing bracket has temporary adhesive strips to hold the mount in place while the adhesive cures.

For technical drawings and 3-D models, click on a part number.

Use these plastic mounts with metal-detector-grade cable ties when detection and retrieval is essential, such as in food processing applications. Mounts are brightly colored for visibility and contain a special compound that can be picked up by X-ray equipment and metal detectors.

Adhesive-back mounts stick to any clean, smooth surface. All components are FDA compliant. Four-way mounts allow ties to be inserted from any side.

For technical drawings and 3-D models, click on a part number.

Add a hook and loop cable tie to these mounts to secure a bundle.

For technical drawings and 3-D models, click on a part number.