Choose when these switches reset to control the pressure range between when they activate and deactivate, commonly referred to as deadband and differential. You can adjust their reset point anywhere along the setpoint range. When they reach the set pressure, these switches power equipment, signal controls, or trigger alarms. They’re single pole, double throw (SPDT) and can either turn one device from off to on (normally open) or on to off (normally closed). UL listed and CSA certified, all meet American and Canadian safety standards. Those that are CE marked meet European safety standards. All protect against some corrosion.

When these switches reach a set pressure, they send electronic signals to your programmable logic controller (PLC) to activate automated controls or alarms. Easily adjust the setpoint by twisting the external ring. An indicating pointer and incremental markings make sure adjustments are precise. When you have your setpoint, tighten the locking ring to prevent unintentional changes. Pair these switches with an M12 socket to quickly connect and disconnect them.

Rated IP67, these switches seal out dust and water from temporary submersion. All are UL and C-UL listed as well as CE marked, which means they meet U.S., Canadian, and European safety standards.

Compatible with most air systems, these switches send digital signals to a programmable logic controller (PLC) to trigger separate processes when they reach either of their two set pressures. For example, they’ll activate a compressor if the pressure is too low or a relief valve if the pressure is too high. Or use them to signal an alarm before switching off a compressor. Some of these switches also work with liquids and gases, so they can be built into hydraulic systems and wet or humid environments, such as cleaning lines.

Monitor your pressure on the display and change your setpoints, reset points, scaling, and other settings using the buttons. An adjustable reset point means you can control the amount of pressure change before the switch resets, also known as deadband or differential. Choose anywhere within the setpoint range for your reset point. Add a panel-mount bracket (sold separately) to mount these switches to a control panel for easy viewing and adjusting.

Rated IP65, they seal out dust and water from washdowns. Switches are UL and C-UL recognized components and CE marked to meet American, Canadian, and European safety standards.