These separators have higher flow rates compared to our other compressed air separators. Prevent equipment damage and wear caused by moisture in your compressed air supply. The first step in water removal, use one of these separators to remove the large amount of water created as compressed air cools.

Remove oil from condensate without needing to service these separators when they’re full.

Let these separators handle the dirty work of condensate disposal. These separators use two-stage filtration to cut oil content to under five parts per million.

Extend the service life of air-powered tools and equipment by removing particles and water droplets from compressed air.

Extend the service life of air-powered tools and equipment by removing particles and water droplets from compressed air.

Extend the service life of air-powered tools and equipment by removing particles and water droplets from compressed air.

Extend the service life of air-powered tools and equipment by removing particles and water droplets from compressed air.

Use these filters where high water and dirt removal is needed—they have a two-layer filter element made of stainless steel wire mesh and cotton/polyester packing.

Quickly install these filters on your air line—no pipe nipples or joiner clamps required. Their push-to-connect fittings create tight seals around tubing.

The housing and bowl are 316 stainless steel to handle extremely corrosive environments such as those in semiconductor, marine, chemical, and paper industries.

Remove particles from large volumes of compressed air without causing restriction or drops in pressure.

Discharge up to 300 gallons of water and particles per hour—these filters handle compressed air that’s high in moisture content.

Housing and bowl are 304 stainless steel for good corrosion resistance in damp environments.

Often used in medical device manufacturing and food-processing facilities, these filters have a stainless steel element that can be sterilized in an autoclave.

A filter and regulator joined top-to-bottom, these filter/regulators fit in the same space as a filter alone.

A filter and regulator joined top-to-bottom, these filter/regulators fit in the same space as a filter alone.

A filter and regulator joined top-to-bottom, these filter/regulators fit in the same space as a filter alone.

A filter and regulator joined top-to-bottom, these filter/regulators fit in the same space as a filter alone.

A clear polyurethane bowl makes these filter/regulators chemical resistant for use with synthetic compressor oils and cleaning fluids and allows you to see inside to monitor contents.

With ±0.2 psi accuracy, these filter/regulators provide more precise control than our other compressed air filter/regulators.

A stainless steel housing and bowl allow these filter/regulators to withstand corrosive environments in the semiconductor, marine, chemical, instrumentation, and paper industries.