These rods and discs are precision ground to offer tighter tolerances than standard 6061 rods and discs.

Precision ground and held to a strict straightness tolerance, these rods are ready for turning in a lathe.

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Secure two linear motion shafts parallel to each other and the mounting surface to build a system that moves smoothly and doesn’t bind.

Create a support that fits the exact dimensions of your shaft to brace it along a flat surface. Good for use with square- and hex-profile shafts, these aluminum supports also work with round shafts of any diameter up to 1". Use them for light-to-medium-load linear motion applications where shaft alignment is not critical.

A removable collar allows access to the shaft without unbolting the flange. For use with light to medium loads where shaft alignment is not critical, these supports allow you to hold linear shafts perpendicular to the mounting surface. Secure the shaft by tightening the clamping screw.

Position shafts an inch or two off the ground to maintain bearing and part clearance. Support rails provide stability over the entire length of shaft, allowing virtually unlimited travel lengths and eliminating bending under moderate to heavy loads.