Connect a tube fitting and tubing to the dispenser outlet to access hard-to-reach lubrication points.

A sealed design prevents contamination in dirty and dusty environments.

Customize these dispensers to serve up to 24 lubrication points from a single location.

Control the flow of oil to a single lubrication point.

Mount these directly to your machine—the cup allows oil to gradually pass through to equipment, reducing time spent on manual lubrication.

A sealed design prevents contamination in dirty and dusty environments. Install a line between the reservoir's pressure port and the lubricated equipment to balance pressure.

Deliver an equal amount of oil to multiple lubrication points at once.

For use in clean environments, these manifolds have multiple air vents that keep pressure balanced.

Manually adjust the flow of oil to a single lubrication point.

Flip the lever to start and stop flow.

Use these brushes to lubricate chain, gears, and conveyors. Connect to an oil dispenser, then turn the dial to adjust flow.

Set the cycle interval as well as the dispensing duration. This pump has a maximum flow of 0.1 oz. per second.

With a maximum flow of 0.005 oz. per cycle, these pumps deliver small, precise amounts of oil. Turn the dial to set the cycle interval.

Connect these modular pumps to a reservoir and a solenoid valve to automate the flow of oil.

Dispense a fixed amount of oil by pumping the handle.

Deliver a mist of oil using shop air.

Pull the trigger on these oilers for easier one-hand operation than standard hand-held oil dispensers.

Driven by an air-powered pump, this dispenser comes with an adapter to mount through a bung opening on a drum.

For more control over the flow rate of your grease, choose these gas-driven dispensers over spring-driven dispensers. Their continuous flow automatically adjusts based on the dispensing duration you set on their dial (from one to 12 months).

Send precise amounts of grease to multiple lubrication points at regular intervals, so each point will always have the grease it needs.

Don’t wait for grease to travel through a new service line—install this grease-filled tubing between the pump and a lubrication point to begin lubricating immediately.

Switch between high-pressure and low-pressure settings. Use high pressure to dispense thicker grease or to force grease through clogged fittings. Use low pressure for high-volume dispensing.

A display allows you to monitor how much grease is dispensed.

Thread these fittings into motors, bearings, engine blocks, and other machinery to create a lubrication point.

To protect equipment from damage, the slit in the threads of these fittings acts like a breather vent, releasing any excess pressure and grease.

The pins on these fittings lock with dispensing tips for pin-style fittings to create a tight seal.

Often used on earth movers, mining equipment, and other heavy machinery, these fittings have a T-shaped top that holds the dispensing tip in place so it won't pop off when adding grease.

To fit securely in unthreaded holes, these fittings cut threads as they’re installed.