These face masks meet NFPA 70E standards for protection against electrical arc flashes for personal protection equipment (PPE) category 2. Check the PPE category and minimum arc rating provided for your workplace, and then select all required clothing and personal protective equipment to meet the minimum arc rating. Arc rating measures a garment’s ability to insulate the wearer from burns; the higher the arc rating, the greater the flame resistance. These hats are made of abrasion-resistant aramid/viscose blend fabric, which keeps you warm without accumulating moisture.

These face masks are double-layered to protect your head from radiant heat, flames, and welding sparks. They are designed to meet NFPA 1971 standards for structural firefighting. Check the PPE category and minimum arc rating provided for your workplace, and then select all required clothing and personal protective equipment to meet the minimum arc rating. Arc rating measures a garment’s ability to insulate the wearer from burns; the higher the arc rating, the greater the flame resistance.

Shield your face and neck from flame and electrical hazards while working in the cold.

Withstand flash fire for up to 8 seconds—the clothes in these kits can protect you for twice as long as most flame-resistant clothing. Made of rayon/aramid, the coveralls and mask absorb moisture to keep you cool and comfortable.

The coveralls have a 10 ft. Kevlar strap, so nearby teammates can pull you to safety without putting themselves at risk if there’s a fire. The reflective stripes keep you easy to see where there's low visibility. The zipper closure on the front is covered by a hook-and-loop flap so it doesn't scrape equipment or get hot. The legs have zippers on the sides as well, so you can fit them over bulky boots. Tighten the hook and loop straps on the bottom of the pants to keep flames out. The sleeves have cuffs with thumb holes to keep the sleeves in place and prevent flames from sneaking in. When measuring chest size, measure around the fullest part of your chest. Take all measurements over any clothing you expect to wear under the coveralls.

Prevent dust, microbes and other pollutants from contaminating a clean room. When laundered to clean room standards, these hoods can be reused up to 100 times. Wash them prior to first use and after each use.

All hoods are suitable for use in clean rooms rated to both Federal Standard and ISO classes. In both standards, clean rooms with lower class ratings have fewer contaminants.

Prevent sunburn and heat stress. These neck gaiters stop 98% of the sun’s rays from hitting your face and neck. Since they prevent bacteria growth from sweat, they won’t smell. To cool yourself off, wet them with cold water and airflow will create a cool, damp feeling.

Designed to meet clean room standards, these hoods prevent dust particles and microbes on you from contaminating a space. Made of polyethylene/Tyvek, they hold up to limited contact with nonhazardous liquids, such as water and paint spray. The heat- and pressure-bonded fibers make these hoods soft yet strong. You can throw them out after you’re done using them.

Breathable to keep you cool and comfortable, these hoods protect against dirt and grime. An elastic face opening keeps hair in and contaminants out.

Get up close to your welds with these goggles. Their lightweight, compact design lets you weld in tight spots or awkward positions. A flame-resistant hood shields your ears, head, and neck from sparks and spatter better than traditional welding helmets. For different protection needs, wear them over prescription glasses, under a hard hat, or without the hood. Use the external controls to adjust power and shade settings without removing these goggles.

As you begin to weld, two sensors detect the light and automatically darken the lens. Unlike traditional green welding lenses, these goggles use a true color lens to enhance clarity and color accuracy. They allow for a better look at your weld pool to increase weld quality and reduce eye strain.

Keep cool while staying shielded from flame and electrical hazards.