McMaster-Carr logo
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    1 Product

    Large-Cell Batteries for Continuous Use

    Image of Product. Front orientation. Batteries. Large-Cell Batteries for Continuous Use, Stud-Terminal Inside Post Battery Connection.
    Image of Specification. Front orientation. D.

    Stud-Terminal Inside Post

    Battery Connection

    D

    For use in floor-cleaning machines, lift trucks, personnel carriers, and other vehicles that require power over an extended time, these deep-cycle batteries can handle many charge/deep-discharge cycles. They are wet cell, so they contain electrolyte in an unsealed container and must be mounted upright. They may occasionally need to be filled with distilled water.
    Reserve capacity is the number of minutes that a new, fully charged battery can continuously discharge at 25 amps at 80° F. Marine cranking amps is the maximum amps that a new, fully charged battery can continuously deliver for 30 seconds at 32° F.
    Warning: Batteries should always be charged and discharged in a ventilated area.
    Voltage,
    V DC
    Battery
    Size
    Mfr. Equiv.
    No.
    Battery
    Cap., A·h
    Battery Terminal
    Configuration
    Reserve
    Cap., min.
    Marine Cranking
    Amps
    Thread Size
    Ht.
    Wd.
    Dp.
    Each
    Wet Cell Lead Acid
     
    Stud-Terminal Inside Post Battery Connection
    123131M115D2059005/16"-18 (Negative Terminal), 3/8"-16 (Positive Terminal)9.4"13"6.8"000000000000000
    Large-Cell Battery for Continuous Use, 12 Volt
    EachIn stock
     
    back to top