Filter by
System of Measurement
Material
ID
For Load Direction
Thickness
Ball Material
Bearing Type
Shaft Type
Dynamic Thrust Load Capacity
Ball Bearing Profile
Cage Material
Static Thrust Load Capacity
Washer Material
Maximum Temperature
Bearing Seal Type
U.S.–Mexico–Canada Agreement (USMCA) Qualifying
DFARS Specialty Metals
Minimum Temperature
Rotation Speed
REACH
RoHS
Performance
Thrust Ball Bearings
 |
 |
For silky-smooth motion, the balls inside these bearings roll nearly friction-free. You'll often find them at the end of a shaft or between a stationary and rotating surface, such as on a propeller or rotary table.
These bearings come as three separate pieces—one cage and two washers. The cage holds the balls in place, while the washers create a surface for the balls to roll on. This design is easy to lubricate, but the oil will attract dust and grime since it's exposed.
Steel—Strong and wear resistant. However, these bearings are best for dry environments since moisture will cause them to rust.
Stainless Steel—These bearings won't degrade from water or mild chemicals, such as the ammonia in cleaning solutions. However, they're not as strong as steel bearings.
Press-Fit Reamer Bushings
 |  |
With ID tolerances sized specifically for reamers, these bushings ensure steady and precise hole finishing. Press them into a fixture plate with a manual or hydraulic press for permanent installation. Also known as headless bushings, these ANSI-type P bushings don’t need counterboring to be mounted flush. They are made of hardened, ground steel that holds its shape and resists wear, so they last for many cycles without needing to be replaced.
Tolerance | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
ID | OD | Lg. | For Reamer Dia. | ID | OD | Lg. | Drill Bushing Type | Material | Hardness | Each | ||
| 0.1905" | 5/16" | 1/2" | 0.1905" | 0.0005" to 0.0008" | 0.0013" to 0.0016" | -0.01" to 0.01" | P | Steel | Rockwell C61 | 9473N244 | 00000 | |
