McMaster-Carr logo
    Filter by
    System of Measurement
    OD
    Attribute Image
    Shaft Diameter
    Material
    Thickness
    Bearing Type
    Industrial Info Compare
    Width
    For Load Direction
    Plain Bearing Type
    Minimum Temperature
    Dynamic Thrust Load Capacity @ Speed
    DFARS Specialty Metals
    U.S.–Mexico–Canada Agreement (USMCA) Qualifying
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Shaft Type
    Lubrication
    Construction
    Backing Material
    Washer Material
    Roller Bearing Type
    Maximum Temperature
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    3 Products

    Dry-Running Metal-Reinforced Plastic Thrust Bearings

    Image of Product. Front orientation. Thrust Bearings. Dry-Running Metal-Reinforced Plastic Thrust Bearings.
    Combine naturally slippery PTFE with the strength of metal. These bearings don't need lubricant, so there's no oil to maintain, drip off, or attract dust. Backed with steel, they're as strong as other all-metal thrust bearings. However, they're best for dry environments since moisture will cause the steel to rust.
    For Shaft
    Dia.
    OD
    Thk.
    Dynamic Thrust Load
    Cap. @ Speed
    Temp. Range,
    ° F
    Each
    Steel-Backed PTFE
    2 1/8"3 1/8"3/32"17,100 lb. @ 30 rpm-320 to 5301262N38000000
     

    Washers for Needle-Roller Thrust Bearings

    Image of Product. Front orientation. Thrust Roller Bearing Washers.
    Adapt needle-roller thrust bearings to use on unhardened, unground surfaces.
    For Shaft
    Dia.
    OD
    Thk.
    Washer
    Material
    Each
    2 1/4"3 1/8"3/32"Steel5909K982000000

    Hub-Mount Screw-Clamp Bushings

    Image of Product. Front orientation. Pulley and Sprocket Bushings. Hub-Mount Screw-Clamp Bushings.
    Image of Attribute. Side1 orientation. Hub-Mount Screw-Clamp Bushings.

    Transfer torque directly from a shaft to a hub. These bushings install over your hub to mount a sprocket, pulley, or gear to a shaft at the same time. Common in industrial gearbox applications, they can also connect a hollow shaft over a solid shaft. As screw-clamp bushings, they're good for shock loads. When you tighten the included clamping screws, the outer rings compress against a sprocket, pulley, or gear in between them, causing the inner rings to tighten around the shaft.
    For Shaft
    Dia.
    OD
    Overall
    Wd.
    Max. Torque,
    in·lbf
    Fastener Tightening
    Torque, in·lbf
    Each
    Zinc-Plated Steel
    1 11/16"3 1/8"1 1/8"8,1501007654N140000000
     
    back to top