System of Measurement System of Measurement |
|---|
|
OD OD | Show |
|---|
|
OD OD | Hide |
|---|
For Housing ID For Housing ID |
|---|
|
For Load Direction For Load Direction |
|---|
 | Combined Radial, Thrust, and Moment |
For Shaft Type For Shaft Type |
|---|
 | Round |
Bearing Type Bearing Type |
|---|
 | Roller |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
Construction Construction |
|---|
|
Dynamic Combined Load Capacity Dynamic CombinedLoad Capacity |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Minimum Temperature Minimum Temperature |
|---|
|
Roller Material Roller Material |
|---|
|
Static Combined Load Capacity Static CombinedLoad Capacity |
|---|
|
Lubrication Lubrication |
|---|
|
Maximum Speed Maximum Speed |
|---|
|
Ring Material Ring Material |
|---|
|
Roller Bearing Type Roller Bearing Type |
|---|
|
About Ball and Roller Bearings
More
Crossed-Roller Bearings
With a considerably larger ID than our Face-Mount Crossed-Roller Bearings, use these to run hydraulic lines, electrical wiring, and other components through the inside of the bearing. The rollers face in alternating directions to allow for rigid, accurate motion under any combination of radial, thrust, and moment (twisting) loads. Use in applications where highly accurate motion is necessary, such as machine tools and industrial robots.
Open bearings dissipate heat more efficiently than sealed bearings.
For technical drawings and 3-D models, click on a part number.
Combined Load Cap., lbs. | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| For Shaft Dia., mm | For Housing ID, mm | Wd., mm | Ring Material | Dynamic | Static | Max. Speed, rpm | Lubrication | Temp. Range, °F | Each | |
Open | ||||||||||
| 50 | 61 | 5 | Steel | 510 | 710 | 1,300 | Required | 0° to 230° | 0000000 | 0000000 |
Quick-Grip Screw-Clamp Bushings
Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed. As you tighten the collar nut, the inner sleeve contracts onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear.
For technical drawings and 3-D models, click on a part number.
| For Shaft Dia. | OD | Overall Wd. | Max. Torque, in.-lbs. | Each | |
Zinc-Plated Steel | |||||
|---|---|---|---|---|---|
| 35mm | 61mm | 70mm | 6,400 | 0000000 | 0000000 |