Increased iron content makes these bearings stronger and more resistant to shock loads than standard oil-embedded bearings; however they operate at lower speeds.

With a flexible layer of rubber sandwiched between an oil-embedded bronze bearing and rigid metal shell, these bearings reduce wear and machinery noise.

With extra iron and filled with oil containing slippery PTFE, these bearings support heavy loads that frequently start and stop along shafts. They’re sleeve bearings, so they handle loads parallel to the shaft.

Embedded with oil that is safe for incidental contact with food, these bearings are suitable for use in high-load applications such as bottling and filling lines in food processing plants. They are also known as Super Oilite® bearings.

Use where high loads and speeds are not required.

Graphite provides a layer of dry lubrication that can operate in high-temperature environments.

These bearings stand up to a wider range of chemicals than other dry-running sleeve bearings.

Good for underwater applications, these bearings won’t swell or warp when wet.

Even in the presence of harsh chemicals and extreme temperatures, these bearings operate under heavy loads and at high speeds.

A figure-8-shaped groove provides a flow path for lubricant, distributing it evenly along the bearing’s surface.

Grooves on the inside of the bearing provide a flow path for lubricant, distributing it evenly along the bearing’s surface.

Use these UHMW bearings in wet, corrosive environments.

Made of acetal blended with PTFE, these bearings handle speeds twice as fast as standard sleeve bearings.

Startup friction causes these porous bronze bearings to release a thin layer of oil on the bearing’s surface.

With a flexible layer of neoprene sandwiched between an oil-embedded bronze bearing and rigid steel shell, these bearings reduce wear and machinery noise.

Use these nylon or acetal bearings for light loads. The closed backing blocks out dust and other contaminants.

Handling speeds twice as fast as standard mounted sleeve bearings while limiting wear on your system, these bearings are made of PTFE-filled acetal.

Made of FDA listed PEEK, these bearings are suitable for direct contact with food. The closed backing blocks out dust and other contaminants.

Replace worn or damaged wheel bearings to keep your equipment rolling.

A handle on the side of the carriage locks the carriage in place.

With a wide base, these sleeve bearing carriages stabilize moment (twisting) and off-center loads better than standard carriages. Use in areas where multiple carriages or rails won't fit.

For applications with low clearance, these carriages protrude less than 5 mm above their rails.

Threaded inserts secure the bearing to the carriage and prevent it from loosening due to frequent starts and stops.

Fasten loads on the side of these carriages and add linear motion to a T-slot assembly.

C-shaped guide rails grip the carriage around the outside to support linear motion along walls and other vertical surfaces.

A handle locks these carriages in place on curved paths, loops, and circuits in assembly stations and other repetitive processes.

A linear scale and micrometer-like hand wheel measure travel distance in increments of 0.001".

Mount components to these load-rated bearings and track rollers to add linear motion along T-slotted rails.