Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

A nonreflective black oxide finish prevents glare that can interfere with machine vision systems.

The handle locks in a horizontal position for more clearance above the clamp than standard hold-down toggle clamps.

Hold workpieces of different thicknesses without adjustment.

Push the lever to lock the handle and prevent accidental opening.

Often used when assembling small parts, these small clamps have the holding strength of a full-size clamp.

Mount these clamps below a surface.

Bolt to the side of an object. Often used to clamp lids and covers on containers.

The mounting base secures these clamps to a rail or bar.

Suitable for production applications, these clamps have double the service life of other air-powered toggle clamps.

Mount the base to a work surface using screws.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Secure these clamps to a rail or bar.

A removable, heavy duty steel base plate provides a flat, durable clamping surface. Carry it where needed or mount the base plate to your workbench.

An alternative to setup clamps, these heavy duty clamps have high holding power to secure workpieces during machining.

Eliminating the need for step blocks or other rear support, the pivoting rocker clamps workpieces of various thicknesses.

Good for occasional machining, economy kits contain lower-strength components than standard kits.

Instead of a step block, support these clamps using a screw, leveling mount, or any other threaded object.

The built-in T-slot nut on these side clamps lets you clamp a part to a machine table quickly. Their small footprint leaves more free space on your table than standard side clamps.

The stepped end provides support and quick height adjustment when paired with a step block.

Keep setup clamps from falling out of position when they are unclamped—the spring holds them up for quick workpiece insertion and removal. Also known as spring lifters.

Smaller than standard setup clamps, these clamps leave more usable space on a machine table when mounting a vise.

A plastic pad on the gripping surface of these clamps prevents workpiece marring, making them useful for holding polished surfaces and reducing the need for secondary finishing steps.

Each arm has a handle for turning the magnets on and off.

Hold and align up to three workpieces at 90° angles.

Switch the magnets on these clamps on and off for easy placement and removal of your workpiece.

Fit the draw arm over a latch plate and pull the handle to clamp.

Mount the clamp on a lid and the latch plate on the side of a container.

With five times the capacity of standard corner clamps, these secure two workpieces at a 90° angle.

Install these clamps into a slot in your fixture to grip at the bottom of a workpiece edge, giving the cutting tool maximum access.

Set one of these clamps between two workpieces in a fixture and tighten the screw to push the clamp's sides out for a secure hold.

Machine these clamps to match the contours of your workpiece and turn the screw to grip.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".

Hold a workpiece securely from the side with minimal contact, leaving more of the workpiece free for machining.

Mount using the holes in the base.