Made of materials that are Factory Mutual approved, these wrenches inhibit sparking and are nonmagnetic and corrosion resistant. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

An extra-long handle provides access to hard-to-reach fasteners and increases leverage.

A lever reverses the ratchet direction.

Flip these wrenches over to ratchet in the opposite direction.

Suitable for occasional maintenance work, these sets are imported.

Quickly find the wrenches you're looking for with these brightly colored sets.

Made of aluminum-bronze that is Factory Mutual approved, these wrenches inhibit sparking and are nonmagnetic and corrosion resistant.

Made in the U.S.A., these tools handle the toughest industrial applications, provide the best grip on fasteners, and have a superior finish.

Flip these wrenches over to ratchet in the opposite direction.

A spline-shaped box end turns spline, hex, and 12-point fasteners. This shape also gets a better grip on rounded fasteners that can be difficult to turn with a traditional wrench.

Made in the U.S.A., these tools handle the toughest industrial applications, provide the best grip on fasteners, and have a superior finish.

Ratchet mechanisms allow you to turn fasteners in tight spaces without removing and repositioning the tool.

An insulated handle protects against accidental contact with live electrical circuits. These wrenches are tested to 1,000 volts to meet IEC 60900.

The offset head gives you additional clearance to turn hard-to-reach fasteners.

Open the jaws to fit around a fastener like an open-end wrench; close the jaws and the wrench acts like a ratcheting box wrench.

The heads are angled to provide clearance around obstructions.

The long handle provides extra leverage—add an extension to increase it even more.

Also known as slugging wrenches, strike the handle with a hammer to break stuck fasteners free.

The head is offset 45° to provide clearance for reaching over obstructions.

A ratchet mechanism allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

Open the jaws to fit around a fastener like an open-end wrench; close the jaws and the wrench acts like a ratcheting box wrench.

Mount to walls, cabinets, and other steel surfaces.

Set on a benchtop or mount with screws.

Tabs hold wrenches in place.

Make maximum contact with all sides of a fastener to reduce slipping. These sockets are also known as torque adapters.

Also known as bung wrenches, these tools are used to install and remove screw-in drum plugs.