Combine naturally slippery PTFE with the strength of metal. These bearings don't need lubricant, so there's no oil to maintain, drip off, or attract dust. Backed with steel, they're as strong as other all-metal thrust bearings. However, they're best for dry environments since moisture will cause the steel to rust.

Slide these traditional collars from one end of the shaft and tighten the set screw. They dig into the shaft for a secure hold, but one that leaves a gouge. For maximum holding power, make sure the set screw is harder than the shaft.

Lightweight alternatives to metal two-piece collars for weight-sensitive applications. Attach these collars anywhere along a shaft when other components are already installed or you can't access the ends. They clamp firmly and evenly without marring the shaft, so you can reposition or remove them later.

Slide these collars from one end of your shaft and tighten the clamping screw. They grip firmly and evenly without marring the shaft, so you can reposition or remove them later.

Ideal for frequent setup changes in tight spaces, these collars tighten with a lever instead of a screwdriver. Slide them from one end of your shaft and turn the lever like a ratchet to secure. To reposition or remove collars later, use the lever to loosen the screw and release the hold.

Attach these collars anywhere along your shaft, which helps when other components are already installed or you can't access the end. They clamp firmly and evenly without marring the shaft, so you can reposition or remove collars later.

Skip the screwdriver—tighten these collars by turning the lever like a ratchet instead. They're ideal for packing, printing, label-feeding, and other equipment requiring frequent setup changes in tight spaces. Attach them anywhere along your shaft, which helps when other components are already installed or you can't access the ends. To reposition or remove collars later, use the lever to loosen the screw and release the hold.