System of Measurement System of Measurement |
---|
|
Thread Size Thread Size | Show |
---|
Thread Pitch Thread Pitch |
---|

|
Thread Type Thread Type |
---|
Nut Type Nut Type |
---|
![]() | Round |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
Thread Spacing Thread Spacing |
---|
Face Style Face Style |
---|
|
For Lock Washer Specifications Met For Lock WasherSpecifications Met |
---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Material Material |
---|
|
About Shaft Collars
Shaft collars are useful for holding and positioning components on a shaft. They can also serve as mechanical stops and stroke limiters.
More
Bearing Retaining Nuts

Often paired with spring lock washers to strengthen their hold, these retaining nuts—also known as shaft nuts—keep vibration from shifting bearings, bushings, pulleys, and gears on your threaded shaft or spindle. They have slotted sides, so you can tighten and loosen them with a spanner wrench or spanner socket. Made of carbon steel, they’re strong and wear resistant.
Use stepped-face retaining nuts with DIN 462 spring lock washers. You can also use them in pairs or with other bearing retaining nuts as jam nuts. For the nut closer to the bearing, position the stepped face towards the bearing. All meet DIN standards for bearing lockout dimensions.
For technical drawings and 3-D models, click on a part number.
Thread | ||||||||
---|---|---|---|---|---|---|---|---|
Size | Pitch, mm | Spacing | OD, mm | Wd., mm | Specifications Met | For Lock Washer Specifications Met | Each | |
Carbon Steel | ||||||||
Stepped Face | ||||||||
M26 | 1.5 | Extra Fine | 45 | 10 | DIN 1804 | DIN 462 | 0000000 | 000000 |
Bearing Retaining Jam Nuts


Used in pairs or with another bearing retaining nut, these jam nuts—often called shaft nuts—hold bearings, bushings, pulleys, and gears in place on your threaded shaft or spindle. Threading two nuts tightly against each other makes it harder for vibration to loosen your assembly than if you used only one nut. For the nut closer to the bearing, position the stepped face towards the bearing. These jam nuts have holes on the side, so you can tighten and loosen them with a pin spanner wrench. Made of carbon steel, they’re strong and wear resistant. All meet DIN 1816, an international standard for bearing locknut dimensions.
For technical drawings and 3-D models, click on a part number.
Thread | |||||||
---|---|---|---|---|---|---|---|
Size | Pitch, mm | Spacing | OD, mm | Wd., mm | Specifications Met | Each | |
Carbon Steel | |||||||
Stepped Face | |||||||
M26 | 1.5 | Extra Fine | 45 | 10 | DIN 1816 | 0000000 | 000000 |