A thick rubber insulation resists cuts and abrasion, so this cable can be pulled over rough surfaces without damaging the wires inside.

Often used in automated applications such as robotics and cable carriers, this cable withstands continuous motion without degrading data or signal transmission.

A thick outer layer of silicone rubber insulation protects this cable from high voltages while remaining ultra flexible. It stands up to continuous motion without degrading data or signal transmission.

In addition to handling continuous movement, this cable withstands twisting up to 450° without degrading data or signal transmission. It's often used in welding robots and rotary tables.

Send data between computers, printers, servers, and switches.

Also known as plenum cable, this cable has low-smoke insulation and can be used without conduit in ductwork and above a drop ceiling. Use it to send data between computers, servers, and switches.

Also known as plenum cable, this cable has low-smoke insulation and can be used without conduit in ductwork and above a drop ceiling. It has an oil-resistant insulation to protect wires as the cable moves from duct to equipment or machinery.

Use this cable for complex and high-speed data and signal transmission.

Connect devices such as sensors, programmable logic controllers, and actuators to an automated network.

Connect low-current circuits such as intercoms and security systems to a building's electrical system in single-level facilities.

This wire meets stringent military specifications for material quality.

Run power over rough surfaces—this wire has thick insulation that stands up to wear and tear.

The PEEK insulation on this wire won't degrade when exposed to radiation, and is often used in nuclear energy production.

Nearly half the diameter and up to 40% lighter than standard wire of the same gauge and voltage, this wire fits in tight spaces.

Use this wire in automated applications that require 14,000 volts A/C or greater. It withstands continuous motion without degrading data or signal transmission.

Assortments include wire in multiple lengths and colors.

This wire wraps around a post terminal on a circuit board to make an electrical connection, eliminating the need for soldering.

Also known as magnet wire, this wire is commonly used in motors, transformers, relays, and other high-speed winding applications.

The shielding blocks signal interference from nearby equipment and devices.

To send high-speed data in tough, rugged environments, these cords have an M12 connector on one end that threads onto switches, sensors, and other devices prone to vibration. The other end has a traditional RJ45 plug that connects to Ethernet equipment, such as computers, IO modules, and programmable logic controllers (PLCs).

Use these unshielded cords where signal interference is not a concern.

FDA compliant for direct contact with food, these cords are safe to use with 12 mm proximity switches, valves, and power supplies in food, beverage, and pharmaceutical applications.

Connect two devices to a distribution block or I/O module with just one cord. Often used with sensors and actuators, these splitters send power/signals to your devices through a single connection.

Block signal interference from nearby devices, such as motors and transmitters, while maintaining a strong, stable connection for M12 threads.

Also known as pico connectors, these connectors are often used with 8 mm and smaller proximity switches and photoelectric switches.

Visually check that your low-current devices with M8 connections are powered up and sending and receiving signals. These connectors illuminate green if they have power and yellow if they have signal.

Use these connectors and cords to make Ethernet connections in wet location environments.