McMaster-Carr logo
    Filter by
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    4 Products

    Caliper Tip Sets

    Image of ProductInUse. Shown Installed. Front orientation. Caliper Tips. Caliper Tip Sets.
    Image of Product. With Ball End, Conical, Flat, and Stem Tips. Front orientation. Caliper Tips. Caliper Tip Sets, Four Pairs of Tips (3/16" Dia. Ball End, 3/16" Dia. Conical, 3/16" Dia. Flat, 3/16" Dia. Stem).
    Image of Product. With Conical, Disk, and Stem Tips. Front orientation. Caliper Tips. Caliper Tip Sets, Three Pairs of Tips (10 mm Dia. Conical, 10 mm Dia. Disk, 2 mm Dia. Stem).

    Shown Installed

    With Ball End, Conical,

    Flat, and Stem Tips

    With Conical, Disk,

    and Stem Tips

    Attach to electronic, dial, and vernier calipers for the added versatility of measuring slots, inside pockets, shoulders, and holes.
    For Caliper Measurement Range
    Material
    Includes
    Each
    0" to 4", 0" to 6", 0" to 8"Stainless Steel
    		Four Pairs of Tips (3/16" Dia. Ball End, 3/16" Dia. Conical, 3/16" Dia. Flat, 3/16" Dia. Stem)
    Hex Key Wrench
    Set Screws
    Two Tip Bodies    		00000000000000
    0" to 6", 0" to 8", 0 mm to 150 mm, 0 mm to 200 mmStainless Steel
    		Three Pairs of Tips (10 mm Dia. Conical, 10 mm Dia. Disk, 2 mm Dia. Stem)
    Hex Key Wrench
    Set Screws
    Two Tip Bodies    		00000000000000

    Caliper Tips for Measuring Center-to-Center Distance

    Image of ProductInUse. Shown Installed. Front orientation. Caliper Tips. Caliper Tips for Measuring Center-to-Center Distance.
    Image of Product. Front orientation. Caliper Tips. Caliper Tips for Measuring Center-to-Center Distance.

    Shown Installed

    Install these tips, also known as centerline gauges, onto the jaws of electronic, dial, and vernier calipers to measure the center-to-center distance between two holes. A 60° conical shape allows the tips to fit snugly into holes.
    For Caliper Measurement
    Range
    Slot
    Wd.
    Lg.
    Material
    No. of
    Tips
    Includes
    Each
    0" to 4", 0" to 6", 0" to 8"1/8"2 5/16"Stainless Steel
    		2Hex Key Wrench00000000000000
    0" to 12"1/8"2 3/4"Stainless Steel
    		2Hex Key Wrench0000000000000
    back to top