These rods are hardened for increased abrasion and impact resistance. Also known as chrome-moly steel, 4140 alloy steel resists fracturing from repeated stress.

Often called ETD-150, these rods are made from a modified version of 4140 alloy steel and have been drawn at high temperatures for excellent strength.

Also known as flat stock, the thickness on these sheets and bars is held to a tight tolerance.

Because the thickness is oversized, you can finish these bars to your exact requirements.

The thickness is oversized for finishing to your exact requirements.

Also known as chrome-moly steel, this versatile 4140 alloy steel is used for a wide range of parts, such as axles, shafts, collets, and die holders. It resists fracturing from repeated stress.

4130 alloy steel has a low carbon content that provides good weldability. It's often used for gears, fasteners, and structural applications.

4130 alloy steel has a low carbon content that provides good weldability. It's often used for gears, fasteners, and structural applications.

Also known as chrome steel, 52100 is an extremely hard and wear-resistant material. These balls are often used in bearings.

Easier to machine than 52100 alloy steel rods, these extremely hard and wear-resistant tubes are often used to create bearings, bushings, and other cylindrical parts that are under constant stress. They’re also known as chrome steel.

Also known as chrome steel, 52100 is an extremely hard and wear-resistant material. This wire is often used for small-diameter bearings, bushings, and punches.

Offering excellent resistance to cracking from impact and compression, C300 alloy steel is often used for dies and tooling. It is also known as maraging steel and VascoMax.

While the low carbon content makes 8620 alloy steel easy-to-weld, it's the nickel, chromium, and molybdenum content that provides wear resistance.

All set for turning in your lathe, these precision-ground rods are held to a strict straightness tolerance.

The thickness, length, and width are oversized for finishing to your exact requirements.

Used in low-pressure pipe lines, these brass fittings have a plating that makes them shiny and improves corrosion resistance.

Typically used with high-pressure brass and bronze threaded pipe fittings.

A free-rotating, permanently attached washer distributes holding pressure over a wider area than a flange and remains stationary to prevent scratching the material surface as you tighten the screw.

These screws have a decorative, domed head that sits above the surface when installed.

A nickel-chrome plating gives these standoffs a mirror-like finish.

Provide a connection for hose cocks, needle valves, and nozzles by attaching these flanges and turrets to your supply pipe.

The two-piece design accommodates a wide range of panel thicknesses.