The spiral flute design pulls chips back toward the tap, so chips won't accumulate in closed-end holes.

Use the extra-long shank to thread deep and hard-to-reach holes.

Sized to cut oversized threads, these tools are often used to tap holes where the threads will shrink due to heat treatment or plating.

Often used for thread repair and occasional hand tapping, these carbon steel taps can thread holes in most metal and plastic, but they have a shorter tool life than standard taps.

Clear chips while tapping deep and hard-to-reach holes. These taps have an extra-long shank for extended reach.

These taps cut left-hand threads while keeping chips clear.

Drill holes and cut threads without switching tools.

With a taper chamfer and bottoming chamfer at opposite ends, these taps start threads easily and are good for threading close to the bottom of closed-end holes.

Coated with chromium carbide or titanium carbonitride (TiCN), these cobalt steel taps cut smoothly through soft material to produce accurate threads.

Tap threads into hardened steel and iron. These cobalt steel taps have straight flutes for high durability.

A high helix angle provides the cutting strength needed to tap threads in titanium. These cobalt steel taps have an open flute design that keeps chips clear, so they don't need to be reversed to prevent buildup.

Create threads sized for pipe and conduit.

With an extra-long shank, these taps have extended reach for tapping deep and hard-to-reach areas in pipe and conduit.

Also known as short-projection taps, these have fewer tapered threads at the tip than standard pipe taps, so you don't have to drive them as deep to produce full threads.

With a taper chamfer on one threading end and a bottoming chamfer on the other, these pipe and conduit taps can start threads easily, and they are able to thread close to the bottom of closed-end holes.

Use these taps on hardened steel pipe and conduit.

The cutting teeth are shaped to cut smooth threads in soft pipe and conduit material.

Cut threads in PG thread sizes commonly used for European conduit.

Use these high-speed steel taps to cut and repair threads in the sizes needed to accept spark plugs.

The coil-style threads produced by these taps are shallower and more widely spaced than standard thread sizes. Use them for quick threading action with compatible fasteners.

Also known as National Gas Outlet (NGO) taps, these tap threads in sizes used for compressed gas cylinders and valves.

For start-to-finish tapping of left-hand threads, these sets include one taper-, one plug-, and one bottoming-chamfer tap.

Multiple tap sizes allow tapping a range of hole diameters. Connect these taps directly to drills, power screwdrivers, and other tools that accept a 1/4" hex shank.

Drill and tap a variety of hole sizes. These taps and drill bits are for use on metal and plastic.

Drill and tap holes in a range of diameters. With a drill bit point to drive into the workpiece, these tools can drill and tap holes in a single step. Connect them directly to drills, power screwdrivers, and other tools that accept a 1/4" hex shank.