Connect two or more of these regulator manifolds to meet multiple pressure requirements from a single air supply—set a different output pressure with each manifold. Use joiner clamps (sold separately) to connect them to other SMC units of the same series, so you can customize your air preparation system. These manifolds come with one regulated outlet on their back and one unregulated outlet. All are relieving regulators, so they exhaust when the downstream pressure exceeds the set pressure. Install them in your air line after filters.

Filter/Regulator/Lubricator Joiner Clamps—Joiner clamps (sold separately) create compact, airtight connections between components. These clamps come with mounting brackets.

Filter/Regulator/Lubricator End Block Sets—End block sets (sold separately) allow you to swap out filter/regulator/lubricator components without unthreading your air line connections. The blocks remain connected to your pipe while you replace components between them.

Compressed Air Regulator Manifold End Caps—End caps (sold separately) seal off any unused pipe ports on SMC modular systems. They attach with a joiner clamp (not included).

Brackets—Mounting brackets (sold separately) allow you to attach regulator manifolds to a wall or equipment.

Supply multiple locations with clean, compressed air at different pressures. These manifolds distribute air from a single supply through regulators with their own pressure controls, so you can adjust each one separately. Regulated air is diverted through an outlet on the back of each regulator, while unregulated air continues through the main line. To control air pressure on the main line, add a standard regulator. All regulators on these manifolds are relieving, so they exhaust when downstream pressure exceeds the set pressure.