Sense objects from farther away than with other DC proximity switches that have the same diameter.

Use these switches to sense metallic objects in environments containing flammable gases and combustible dust. ATEX and IECEx certified to protect against explosion, they produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks.

Eliminate the need to calculate the sensing distance when using different metals—these switches sense all metal at the same distance. Also known as K=1 sensors.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

These intrinsically safe switches detect objects as they’re routed through the ring. They produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks. Switches are ATEX certified to protect against explosion.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

Most often found in older devices, these switches require AC input voltage.

A built-in relay produces AC voltage output. These switches are often used with older programmable logic controllers (PLCs).

For optimal performance in tight spaces, these switches have a smaller beam and can detect smaller objects than standard photoelectric switches.

Safely detect the presence or absence of an object moving at high speeds with a light beam. These switches produce a low-current, low-voltage NAMUR signal, so they won’t create sparks or ignite. ATEX and IECEx certified, they protect against explosion in environments containing flammable gases and combustible dust.

These switches actuate when a magnet comes within sensing distance, and reset when the magnet moves away.

Use a laser to determine the distance to an object up to 700 yards away.

Record steps or miles while you walk or run.

Send sheet, roll, and strip measurements from this measurer to a remote Voltage Actuated Counter (sold separately).

Navigate on foot with real-time GPS data.

Use high-frequency sound waves to detect chemical level.

Measure the level of conductive liquids without drilling a hole in your tank—these switches mount to the outside of the tank and track the capacitance between them and the tank’s contents.

Short probes are built into the tip of these switches.

Detect water level with infrared light to avoid false switch activation caused by vibration in your tank.

Clamp around sensors and switches for a secure hold.

The spring-loaded design absorbs impact to protect sensors and switches from damage.