When one end of these pins wears out, use the other one. They’re also known as barrel drift pins. Use alignment pins to align structural components such as I-beams and angle iron for bolting, riveting, and welding.

Made from aluminum bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant pins inhibit sparking. They satisfy OSHA requirements for nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity. Use alignment pins to align structural components such as I-beams and angle irons for bolting, riveting, and welding.

Note: Do not use these tools in direct contact with acetylene.

When one end of these pins wears out, use the other one. Made from aluminum bronze that is Factory Mutual approved, these nonmagnetic, corrosion-resistant pins inhibit sparking. They satisfy OSHA requirements for nonsparking tools for locations where flammable vapors and combustible residues are present. Nonsparking tools are not, however, classified as antistatic because they do conduct electricity. Use alignment pins to align structural components such as I-beams and angle irons for bolting, riveting, and welding.

Note: Do not use these tools in direct contact with acetylene.

For components you need to lock in place but also disconnect frequently, these pins have a toggle end and large loop handle. No need for a separate cotter pin, the toggle swivels so you can insert into a hole and then swivels back to secure. Fold down the handle to save space when installed.