Pass wires and rods through the hollow body of these vises.

Each end of the vise has a collet to hold a different tool—turn the collar to close the collets around them.

A rubber-covered body provides a comfortable grip. These vises have a rotating end cap on the handle that allows you to apply constant pressure while turning the body of the vise with your fingertips.

The raised flange on these sleeves fits into the notch on removable drill bushings.

These stands hold round-shank drill bits of different sizes. The holes are marked with the bit size and decimal equivalent.

These cabinets have one undivided drawer.

The compartments are sized to hold two reduced-shank drill bits and are marked with the bit size.

Attach to the shank of a drill bit to extend its reach.

Adjust these extensions to the desired length. They have a quick-change mechanism for fast bit changes.

SDS-Plus shanks have two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers. These extensions have a quick-change mechanism for fast bit changes.

Drill, countersink, and drive screws without switching three separate bits in and out of your power tool.

For use in power screwdrivers and impact drivers that accept a 1/4" hex shank, each adapter holds a variety of round-shank drill bit sizes for quick tool changes.

Keep taps and drill bits organized. All holes are labeled with sizes. Taps and drill bits are not included.

Drawers and labeled compartments provide space for keeping tools organized. Taps and drill bits are not included.

Store tools such as brooms, screwdrivers, and flashlights with these holders that attach to magnetic surfaces.

Use hex-shank bits (also known as insert bits) in powered tools.

A magnetic ring at the end of the adapter holds flat-head screws in place to ensure good contact between the bit and screw. Use these adapters to hold hex-shank bits (also known as insert bits) in powered tools.

Keep bits from slipping. Insert a bit into the adapter, place a screw on the end of the bit, and slide the adapter sleeve over the screw. The sleeve retracts as the screw is driven. These adapters hold hex-shank bits (also known as insert bits) in powered tools.

Lock your bit into the adapter to prevent accidental disengagement. These adapters attach to square-drive tools.

Use a 4 mm bit in a bit driver that's designed for 1/4" bits.

Insert these adapters into your SDS-drive rotary hammer to use it with hex-shank bits (also known as insert bits).

Mount the magnetic base to walls, cabinets, and other steel surfaces.

Fit these small cases comfortably in your pocket.

Operate these tools like a standard bit driver and access hard-reach fasteners with the offset head. Insert a bit and a magnet holds it in place.

Drive screws four times faster than ratcheting alone. Grip the speed housing at the base of the shaft with one hand while turning the handle with the other. A magnet at the end of the shaft holds bits in place.

A ratchet mechanism turns fasteners more quickly than a standard bit driver. Insert a bit into the shaft and a magnet holds it in place.

An insulated handle and shaft protect against shock from accidental contact with live electrical circuits. These tools are tested to 1,000 volts to meet EN 60900 and IEC 60900.

Bend the shaft around obstructions to reach fasteners that standard and offset screwdrivers can’t.

When working in tight spaces, these short drivers fit where others can't. Bits have a different tip at each end and snap into the shaft, which is also a nutdriver.