Chill the water in any drinking fountain, bubbler, or bottle filler. These chillers are preset to cool room temperature water to approximately 50° F, a temperature that feels like ice water. Internal thermostats are easy to adjust for colder water. You can also install a drinking fountain nozzle directly to the unit.

The motors and air compressors are low maintenance because they are permanently lubricated. The rust-resistant steel meets national safety and quality standards for drinking water. Chillers need 6” in front of the unit and 3” behind the unit for proper ventilation. For an even better taste, pair with water filters .

Provide drinking water wherever it's needed—no plumbing hookup required. The reservoir detaches for easy cleaning. For proper ventilation, allow 4" on each side and 6" behind the dispenser.

Replace the push bar on your drinking fountain with these motion-sensing converters to dispense water hands-free. When you step in front of the sensor, water starts to flow. These converters are compatible with Elkay EZS drinking fountains and EZS/LZS bottle fillers.

Fill water bottles touch-free. A motion sensor detects when a bottle has been placed in front of it and starts filling. The spout produces a smooth stream that prevents splashing. To see how many single-use plastic bottles you’ve saved, a counter displays how many containers have been filled. Water is chilled to 50° F.

To install, you’ll need to connect the drain to your plumbing system with a P-trap (not included). Install the spout no higher than 48" from the floor to ensure they're accessible. When installed properly, they help you comply with ADA standards.

Often installed in your countertop or sink, these high-clearance bottle fillers automatically start the flow of water when you set a container in front of them. These fillers meet NSF/ANSI 61 standards for drinking water. They have a coating on the spout that prevents buildup and contamination. Connect them to a water source and plug in the included AC transformer or use AA batteries for power. Use the switches on the valve control module to program run time and shut-off settings.

These fillers help you comply with ADA regulations when you install the sensor no higher than 48” from the floor. For accessibility if you have limited mobility or dexterity, the water flows for at least 10 seconds before turning off to give everyone enough time to fill their water bottle.