High-Pressure Leak-Repair Sticks for Metal
To stop leaks in metal tanks and equipment without draining the contents, heat the area with a heat gun or torch to melt the stick and form a permanent seal. The resulting patch can withstand pressure up to 600 psi. These sticks meet NSF/ANSI 61 safety standards for use with drinking water systems.
Container Net Weight, oz. | Begins to Harden, min. | Reaches Full Strength, sec. | Temp. to Begin to Harden, °F | Consistency | Max. Thick. | For Use Outdoors | Temp. Range, °F | Color | Specifications Met | Finishing Method | For Use On | Each | |
0.375 | 1 | 90 | 250 | Putty | 1/8" | Yes | Not Rated to 350° | Green | NSF/ANSI 61 | Sand | Aluminum, Brass, Bronze, Copper, Steel, Stainless Steel, Cast Iron, Titanium | 000000 | 000000 |
Leak-Repair Sticks for Metal
To stop leaks in metal tanks and equipment without draining the contents, rub the smaller stick into the leak until it stops. Then, cut the desired amount from the larger stick, knead to a uniform color to mix, and press into place. The size listed is the combined total of the two parts.
Container Net Weight, oz. | Begins to Harden, min. | Reaches Full Strength, hrs. | Consistency | Mix Ratio | Max. Thick. | For Use Outdoors | Temp. Range, °F | Color | For Use On | Each | |
5.25 | 2 | 24 | Putty | 1:1 | 1/8" | Yes | -40° to 220° | Gray | Aluminum, Brass, Bronze, Copper, Steel, Stainless Steel, Cast Iron, Titanium | 0000000 | 000000 |
Temporary Leak-Repair Sticks for Metal
Stop leaks in metal tanks and equipment without draining the contents. Until a permanent repair can be made, rub these sticks into the leak to form a temporary seal.
Container Net Weight, oz. | Begins to Harden, hrs. | Reaches Full Strength, hrs. | Formulation | Consistency | Max. Thick. | For Use Outdoors | Temp. Range, °F | Color | For Use On | Each | |
1.25 | 12 | 24 | Drying Oil | Putty | 1/8" | Yes | -50° F to 220° | Gray | Aluminum, Brass, Bronze, Copper, Steel, Stainless Steel, Cast Iron, Titanium | 000000 | 000000 |