Nano-sized additives fill small surface imperfections, reducing wear and heat to extend the life of both the lubricant and equipment. These lubricants dry to form a nonstick film that won’t attract dust. They are often used on hinges, gears, and roller chain.

Use these NSF registered H1 lubricants in food-processing and preparation areas with a risk of incidental food contact. They form a nonstick film that won't attract contaminants, such as flour.

These lubricants dry to form a thin, solvent-resistant film that won't squeeze out or attract dirt. They're made with moly to withstand heavy loads and pressure. They can handle low-speed loads at temperatures up to 745° F and static loads up to 2400° F. Also known as thread lubricants, antiseize lubricants prevent threaded fasteners and close-fitting parts from locking together due to corrosion, contamination, or heat.

A high load-carrying capacity makes these lubricants good for use on chain and moving metal parts. They dry to form a film that lubricates without attracting dust.

Made of 98% moly, this lubricant withstands pressure up to 500,000 psi and has excellent wear resistance. Apply it to metal surfaces to prevent parts from corroding or sticking.

Made of graphite, these powders and flakes lubricate under heavy loads and high temperatures. They resist most chemicals and conduct heat and electricity.

Also known as paintable mold-release lubricants, these lubricants don’t leave a residue, so you can paint or finish the molded part without the need to clean it. Apply them to molds before casting so you can easily remove cast parts and prevent sticking, stretching, and tearing.

Reduce mess and waste with these easy-to-apply, nonstaining lubricants. They reduce friction between your cutting tool and workpiece to make cutting cycles faster and easier, improve surface finishes, and extend tool life. All resist running and dripping. They are chlorine free, for use where chlorine waste disposal is a concern, and sulfur free.

Prevent packages from sticking on conveyor rails and chutes.

These easy-to-apply stick lubricants won't drip or run for a cleaner workspace. Use them for tapping many types of metal, as well as plastic and rubber. Apply to taps to make cutting faster and easier, improve surface finishes, and extend tool life. They are chlorine free, for use where chlorine waste disposal is a concern, and sulfur free.

An alternative to nearly dry machining, apply these coolants to tools before milling and machining to reduce heat with minimal cleanup. They’re often used with shallow drilling, reaming, and tapping, as well as on saw blades. Remove from tools and work surfaces with alcohol, methyl ethyl ketone, or a parts washer. They are chlorine free, for use where chlorine waste disposal is a concern, and sulfur free. Use at full strength.