McMaster-Carr logo
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    2 Products

    Turning Vanes for Rectangular Duct

    Image of ProductInUse. Shown Cut and Assembled. Front orientation. Contains Annotated. Duct Turning Vanes. Turning Vanes for Rectangular Duct.

    Shown Cut and Assembled

    Image of Product. Front orientation. Duct Turning Vanes. Turning Vanes for Rectangular Duct, Turning Vanes.

    Turning Vanes

    Guide air smoothly around sharp bends in rectangular duct. Turning vanes improve airflow efficiency by reducing turbulence and pressure loss. Cut vanes and rails to size, then mount the vanes between two rails. Rails have mounting tabs to hold vanes. Mount inside duct using tapping screws (not included).
    Galvanized Steel—Corrosion resistant and affordable, galvanized steel is the most commonly used ductwork material.
    Galvanized Steel
    Wd.
    Ht.
    Lg.,
    ft.
    Ga.
    Each
    Turning Vanes
    2 7/8"1"6261000K5000000
    5 5/8"1 7/8"6241000K600000
     
    back to top