Often used in automated applications such as robotics and cable carriers, this cable withstands continuous motion without degrading data or signal transmission.

Use this cable without conduit in automated applications—it meets crush and impact requirements for exposed runs in cable carriers, and withstands continuous motion without degrading data or signal transmission.

Connect servocontrollers and servomotors in automated equipment and on assembly lines. This cable withstands continuous motion without degrading data or signal transmission.

With a life span of more than 20 million high-speed flex cycles, this cable lasts twice as long as standard continuous-flex cable. The frequent motion will not degrade data or signal transmission.

This cable meets TC-ER crush and impact requirements for exposed runs in cable trays, so it can be used without conduit. It sends signal and data to operate, measure, or regulate automated equipment.

This cable is used in variable-frequency drive motors. It has shielding to block signal interference caused by voltage fluctuations and current spikes.

Approved for flame resistance, this cable meets Mine Safety and Health Administration (MSHA) standards. The insulation resists abrasion and chemicals.

Thick insulation protects the internal wires of these cords, so they can be used in high-traffic areas and over rough surfaces.

The shielding blocks signal interference from nearby equipment and devices.

Run high-definition signals through duct, above drop ceilings, and below raised floors without using conduit.