We will reply to your message within an hour.
Knockouts allow you to modify these boxes to fit your application.
These boxes come ready to use with receptacles and/or light switches installed.
Close off unused outlets.
Add depth to your outlet box.
Add depth to your switch box.
Close off unused switches.
Add depth to octagonal outlet boxes.
With built-in threaded connections, these boxes allow you to attach conduit without using fittings.
Mount these boxes to the outside of an enclosure to access a programmable logic controller or other networked device without opening the enclosure.
Enclose and protect outlets in concrete and under carpeted or tile floors.
Protect the edges of carpet surrounding your outlet boxes.
Designed for commercial use, these heavy duty boxes have thick, rigid walls.
These boxes have an open back to accommodate extra-deep low-voltage devices.
Use the built-in connections to attach conduit without using fittings.
Mount these boxes on the surface of your wall in areas where you can't create a recess.
Build your own outlet box or replace a damaged box.
These boxes come ready to use with receptacles installed.
Exposure to rain, snow, and wet conditions won't damage these corrosion-resistant boxes.
Keep the cover closed during operation to completely shield the outlet and plug from rain, snow, and wet conditions.
These corrosion-resistant covers can withstand rain, snow, and wet conditions without being damaged.
Add depth to your weatherproof outlet box.
These corrosion-resistant boxes are built to withstand exposure to rain, snow, and wet conditions.
Rain, snow, and wet conditions won't damage these corrosion-resistant covers.
Give switches and outlets a finished look.
Close off unused switches and outlets.
Keep switches and outlets under cover for protection from dust and dirt. These stainless steel plates resist corrosion and have a sealing gasket to keep out moisture.
Pair wall plates and adapters to create a custom cover for existing receptacles and switches to give them a rejuvenated look, no rewiring required.
Cover existing outlets and switches for a refreshed appearance, no rewiring necessary.
Snap end and center sections together to create your own two-device or wider wall plate.
These curved outlet strips clamp onto a pole or table leg.
A combination of an outlet box, cord, and duct, these outlet strips minimize tripping hazards and protect the cord from damage.
Keep personnel safe from electric shock with ground fault protection.
Snap these wall plates onto flush-mount outlet strips to secure the outlet strip in a cutout.
For use with washdown receptacles, these outlet boxes withstand corrosive and washdown environments.
Prevent damage to electronic equipment caused by spikes in current. Mount these receptacles to DIN rail.
Attach these general purpose receptacles to DIN rail to bring power closer to where you need it.
Keep personnel safe from electric shock by adding ground fault protection to all outlets on the same circuit. These receptacles mount to DIN rail.