A single-piece construction prevents the contact block from separating from the actuator in high-vibration applications.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Stick these labels to your control board to make it easy to find the stop switch in an emergency.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

Immediately cut power with a single push.

Instantly cut power when obstacles or distance make it hard to reach your machine in time.

Immediately cut power by pulling the cable.

Safe to use near ignitable gases and dust, the housing on these switches seals in anything that could ignite flammable material. Yank the cable anywhere along your line to quickly cut power in emergencies.

Also known as deadman switches, these switches make sure equipment only runs if you lightly press the hand grip. If you let go or a shock tightens your grip, they cut power.

Delay access to hazardous areas until conditions are safe; use these switches with machines that take time to stop after they are turned off. They mount to a door frame.

The convenient, modern alternative to mechanical safety switches. These RFID switches are easier to install, fit a wider range of access points, and can mount horizontally.

Prevent accidental bumps or vibration from triggering these safety switches unnecessarily—a strong magnet maintains the RFID signal between the actuator and switch until it's intentionally opened.

Create a perimeter around machinery by deflecting light beams from a single set of safety barrier switches.

Shut off machinery on your roughest, dirtiest job sites the second someone or something gets too close.

Small yet mighty, these switches are about as tall and wide as an index card yet durable enough to mount directly to a wall.

Protected by a steel enclosure, these switches withstand tougher conditions than switches in a plastic housing. Also known as safety switches, they have quick-make/quick-break action to eliminate arcing and prolong switch life.

Prevent motors and other equipment from overheating or failing from not having enough voltage. When the supply voltage falls below 35% of the rated voltage, these switches will automatically turn off to protect the circuit from undervoltage.

Rated IP69K, these switches are protected from high-pressure and high-temperature washdowns.

Cut power and keep it isolated to prevent equipment from starting up during inspection and maintenance. These switches are housed in a protective enclosure that resists denting, chipping, and cracking.

Install these switches inside an enclosure to prevent it from opening when power is on—turn the switch to disconnect power and release the door.

Often used in electrical enclosures, these switches mount directly to DIN rails. They cut power and keep it isolated to stop equipment from starting up during inspection and maintenance.

Clearly mark the location of stop switches so they’re easy to find in an emergency.

Built into an enclosure, these temperature controllers are protected when sitting on your workbench. They turn heating equipment on and off using a proportional-integral-derivative (PID) control algorithm to make fine adjustments, giving you the most precise and stable temperature control.