These end mills have a diamond or diamondlike coating for machining abrasive material, such as carbon fiber, fiberglass, and graphite. Made of solid carbide, they are harder, stronger, and more wear resistant than high-speed steel and cobalt steel for the longest life and best finish. Their extreme hardness means they are brittle, so a highly rigid setup, such as a CNC machine, is necessary to prevent the end mill from breaking. They have a ball end for milling rounded slots, slopes, and contours. All are center cutting, allowing plunge cuts into a surface.

End mills with fewer flutes provide better chip clearance for high-volume, high-speed plunge, slotting, and roughing cuts; end mills with more flutes provide a finer finish and operate with less vibration when run at high speeds.

Diamondlike-carbon (DLC) coated end mills are an economical option for short runs and intermittent use.

With a diamondlike coating (DLC), these end mills are sharp enough to cut aluminum, brass, and bronze. Often used for slotting and pocketing cuts in mold and die making, they have a 90° profile and rounded corners, which reduce flute breakage and chipping. Also known as corner radius end mills. All are center cutting, allowing plunge cuts into a surface.

Made of solid carbide, these end mills are harder, stronger, and more wear resistant than high-speed steel and cobalt steel for the longest life and best finish on hard material. Their extreme hardness means they are brittle, so a highly rigid setup, such as a CNC machine, is necessary to prevent the end mill from breaking.

Pair these carbide inserts with insert holders to mill the surface of plates and bars. They have a negative rake, so they have cutting edges on both sides—they last longer than comparable positive-rake inserts. As each edge dulls, you can rotate to a fresh one. When all the edges on one side are worn, flip the insert over. Built-in chip breakers prevent long chips from forming, so they won’t block the flow of coolant or damage your tool.

Inserts sold individually come packed in a clear plastic case to protect cutting edges during shipment. Inserts sold in packs come factory sealed from the manufacturer for maximum traceability.