Filter by
System of Measurement
Mill Diameter
Cut Style
Number of Flutes
End Mill Type
Material
Number of Milling Ends
DFARS Specialty Metals
Export Control Classification Number (ECCN)
Finish
Flute Spacing
Flute Type
Length
REACH
RoHS
Shank Type
Sold As
High-Speed Steel Square End Mills
4 Flute
Use these end mills for general purpose milling in most material, such as aluminum, brass, bronze, iron, and steel. They have a square end for milling square slots, pockets, and edges.
End mills with fewer flutes provide better chip clearance for high-volume, high-speed plunge, slotting, and roughing cuts; end mills with more flutes provide a finer finish and operate with less vibration when run at high speeds.
Use uncoated end mills for general purpose milling and short production runs.
Center-cutting end mills allow plunge cuts into a surface.
| Mill Dia. | Shank Dia. | Lg. of Cut | O'all Lg. | Flute Spacing | Helix Angle | For Use On | End Mill Type | Each | |
Uncoated | |||||||||
|---|---|---|---|---|---|---|---|---|---|
4 Flute | |||||||||
| 12.5mm | 12.7mm | 34.9mm | 86mm | Equal | 30° | Aluminum, Brass, Bronze, Iron, Plastic, Stainless Steel, Steel | Center Cutting | 0000000 | 000000 |