Small as hockey pucks, these lightweight strobe lights mount to surfaces and are unobtrusive when they’re turned off.

Easier to spot than other strobe lights, these lights emit bursts of multiple flashes.

Easier to spot than other strobe lights, these lights emit bursts of five flashes per cycle.

These strobe lights flash multiple times per cycle, making them easier to spot than standard strobe lights.

Set these portable lights wherever you need a signal light—they don't need to be wired or plugged in.

Screw into a standard medium-base light socket.

These lights are UL listed for environments where fuels, solvents, acetylene, and other hazardous substances may be present.

Direct your signal with these lights; they flash in one direction.

Quickly position these portable flashing lights using the magnetic base to draw attention to hazards in areas such as docks and railroad crossings. They are battery operated, so they do not need to be wired or plugged in.

These lights can switch between continuous, flashing, or revolving.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.

Mount these lights horizontally or vertically in places where a tower will not fit.

Give a signal with the push of a button. These lights have a control box for activating each of the three light modules.

These lights emit three colors from a single lens and can be mounted in tight spaces where a tower will not fit.

Good for tight spaces where a tower of lights won't fit, these emit three colors from a single lens.

Use a computer to program colors, lighting patterns, and sounds to communicate a variety of status conditions, material levels, and cycle times—these stack lights have 21 colors and 11 sounds.

No need for wiring—these lights plug-in with a two-prong plug.

Illuminate outdoor exit paths and emergency assembly areas during power outages.

Light the path toward exits where combustible gases and dust are constantly present—the enclosure on these lights contains sparks and flashes to prevent a reaction with nearby hazards. They’re often found in extreme environments, such as refineries and chemical plants.

Install these lights in aircraft hangars, gas plants, and other facilities where flammable and combustible gases or dust may be present, such as leaks or ventilation failures. Rated NEC Class I, Division 2, they seal out gases but aren't built to contain explosions.

If the power goes out, you’ll find these flashlights right away.