Also known as troffers, these lights fit most standard drop-ceiling grids and are often used in offices, storage rooms, and other indoor spaces. Drop them into your recessed ceiling grid.

Style A lights give you the classic look of drop ceiling lights. All are rated for use in damp locations. Lights with a smooth, frosted lens can also be mounted directly to a solid ceiling with surface-mount hardware (sold separately) or hung with suspension hardware (sold separately).

IC-rated lights safely dissipate heat, so you can mount them directly against insulation.

Add an emergency backup battery to keep these fixtures lit for 90 minutes if the power goes out.

Upgrade your fluorescent recessed lighting to energy-efficient LEDs without removing fixtures and exposing insulation. No need for a permit—these lights don't require opening the space above the ceiling. They connect to standard housings with the included springs and cables. Just remove the old lens, bulbs, drivers, and their wiring before installation. DLC (DesignLight Consortium) listed, these lights have been tested to confirm their energy efficiency. They’re also ETL listed for use in damp locations.

Adjust the light appearance and brightness to match your existing lighting. The frosted lens disperses light evenly to prevent glare on equipment.

Brighten chemical plants, refineries, and other facilities where flammable and combustible gases, dust, or fibers may be present in the event of a leak or ventilation failure. These lights are rated for use in NEC Class I, II, and III, Division 2 hazardous locations.

Also known as jelly jar lights, they have a heat-resistant tempered glass lens. A guard shields the lens from impacts. These lights are rated IP66 and NEMA 4X for protection from washdowns, dust, and corrosion.

Choose lights with a built-in LED bulb for energy efficiency. The bulb generates less heat than incandescent bulbs and lasts longer.

Fastener-mount lights have holes for permanent ceiling or wall installation. Thread-on lights screw into ceiling-mounted conduit.

Replace the U-shaped fluorescent bulbs in your fixture or upgrade to LED. These bulbs are often used in 2'×2' ceiling lights. Select a light appearance to match your existing lighting. Bulbs with more than one light appearance have a switch which allows you to match other lights in the room.

LED bulbs last longer and are more efficient than fluorescent bulbs. They’re compatible with most instant-start electronic ballasts, or you can use them in sockets wired directly to the power source. Check if your ballast is compatible by selecting a part number and clicking product detail. These bulbs are made for T8 sockets, but can be used in T12 sockets that are wired directly to a power source.