Contain explosions, sparks, and flashes—the enclosure on these ceiling lights makes them safe to use in NEC Class I and II, Division 1 hazardous locations. They meet NEC hazardous location temperature classifications, so their surface stays cool enough to avoid igniting hazardous gases or dust. Designed to resist corrosion from salt water, they’re also UL marine listed. All lights have adjustable mounting brackets that can rotate 45° in either direction to direct light where you need it.

Illuminate outdoor areas such as building grounds and entrance signs with a narrow beam of directed light. Heads adjust to direct light where needed.

Lights with a cool light appearance highlight white/blue tones creating good visibility at night.

Style A have built-in LEDs that last longer, are more efficient, and generate less heat than other technologies. These fixtures can be set to cool or neutral color appearances. They can be hardwired to operate on any of the voltages listed.

Lights with an aluminum housing resist corrosion better than those with a zinc housing.

Light up entryways and paths alongside your building for safe travel after dark. These lights are also known as wall packs. Mount them to outlet boxes on the exterior of your building.

These lights meet UL or ETL for wet locations. Lights rated IP65 are sealed to keep out dust and driving rain.

Styles A-E have a switch for selecting the light appearance. Connect them to your lighting control system or toggle the light sensor to automatically turn them on when it gets dark. Lights with a downcast beam are also known as full cut-off lights. Often installed above doors, they help reduce glare by aiming light down instead of toward your eyes.

Swap new fluorescent light bulbs into your single-pin base fixture, or upgrade them to LED. Select a light appearance to match your existing lighting. Bulbs with more than one light appearance have a switch, which allows you to match other lights in the room.

LED bulbs last longer and are more efficient than fluorescent bulbs. They work with sockets that are wired directly to the power source. T8 bulbs can be used in T12 sockets that are wired directly to a power source.

Plastic-coated glass bulbs are shatter resistant. If the glass breaks, the coating keeps shards from falling.

Replace high-intensity discharge (HID) lights with the longer-lasting, energy-efficient LEDs. Brightness is measured in lumens; the higher the lumens, the brighter the bulb. LED lights are perceived as brighter at night than high-intensity discharge light technologies, so they require fewer lumens to provide the same brightness. Match your old light’s wattage to find the right LED bulb. A bulb’s estimated yearly cost is based on 3 hours of usage per day at $0.11 per kWh.

Ballast bypass bulbs eliminate the need for a ballast, so the socket must be wired directly to the power source.